User manual BARTSCHER 2053901

[. . . ]  The appliance must be installed by a qualified professional according to the instructions provided.  Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Room ventilation The appliance may only be installed in permanentlyventilated rooms, according to current national legislation. The room in which the appliance is installed must be ventilated adequately so as to provide as much air as is needed by the normal gas combustion process (the flow of air must not be lower than 2 m3/h per kW of installed power). [. . . ] V Adapting to different types of gas It is possible to adapt the appliance to a type of gas other than the default type (this is indicated on the rating label on the cover). Adapting the hob Replacing the nozzles for the hob burners: 1. Remove the hob grids and slide the burners off their seats. Unscrew the nozzles using a 7 mm socket spanner (see figure), and replace them with nozzles suited to the new type of gas (see Burner and nozzle specifications table). Replace all the components by following the above instructions in reverse. Unscrew the nozzle using a special nozzle socket spanner (see figure) or with a 7 mm socket spanner, and replace it with a new nozzle that is suited to the new type of gas (see Burner and nozzle specifications table). Turn the knob to the minimum position (MIN) after it has been in the maximum position (MAX) for approximately 10 minutes. Tighten or loosen the adjustment screws on the outside of the thermostat pin (see figure) until the flame is small but steady. 4  In the case of natural gas, the adjustment screw must be unscrewed by turning it anti-clockwise. Turn the knob from the MAX position to the MIN position quickly or open and shut the oven door, making sure that the burner is not extinguished. Adapting the grill Replacing the grill burner nozzle: 1. Using the oven  The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may emit a slightly unpleasant odour caused by protective substances used during the manufacturing process burning away.  Never put objects directly on the bottom of the oven; this will avoid the enamel coating being damaged. Only use position 1 in the oven when cooking with the rotisserie spit. Lighting the oven To light the oven burner, bring a flame or gas lighter close to opening F (see figure) and press the OVEN control knob while turning it in an anticlockwise direction until it reaches the MAX position. timer* To activate the Timer proceed as follows: 1. Turn the TIMER knob in a clockwise direction " for almost one complete revolution to set the buzzer. Turn the TIMER knob in an anticlockwise direction # to set the desired length of time. Place the rotisserie support in position 4 and insert the spit in the hole provided on the back panel of the oven. Acitvate the function by pressing the TURNSPIT button. [. . . ] 11 Care and maintenance GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the oven seals Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. We recommend that the oven is not used until the seals have been replaced. [. . . ]