User manual BARTSCHER 2055901

[. . . ] The appliance must be installed by a qualified technician in accordance with the manufacturer’s instructions. No liability for injury or damage to persons, animals or property will be accepted by the manufacturer arising from failure to follow these instructions. The electrical safety of this appliance is ensured only if it is correctly connected to an efficiently earthed system in accordance with electrical safety regulations. Make sure this basic safety requirement has been complied with. [. . . ] Once this time is up, the word «end» will be displayed and a sequence of acoustic signals will be emitted to indicate that cooking is complete. € Press any button to silence the acoustic signal. € Turn knob “L” back to position 0 to remove the word «end» from the display. And a cooking time of 1 hour and 15 minutes is programmed. Cooking time = 1h15 For example It is 9:00 a. And the end cooking time is set at 10:15 a. Cooking time = 1h15 Time Manual start Automatic stop Delayed cooking programming Press button “4” and then adjust the cooking time by pressing keys s and t. Press the “4” to store the setting. The temperature and the time set previously will be displayed alternately. Press button “3” and then adjust end cooking time by pressing keys s and t. Press the”3" button to store the setting and the display will remind you of the end cooking time and of the temperature set alternately. Safety devices Given the high temperatures reached inside it, the oven is fitted with several safety devices: GB 5 Automatic Cleaning with the Fast Clean Function • • • • The door is locked automatically as soon as the temperature exceeds a certain value, to avoid all risk of burns The heating elements are no longer electrically powered, as a precautionary measure, should a fault occur Once the oven door has been locked, you cannot make any changes to the cycle time and cycle end settings If the temperature in appliance’s electrical component area has reached a safe value, it is not possible to start the “Fast clean” cycle. The word “HOT” will appear on the display. Wait for the cooling fan to switch off before restarting the “Fast clean” programme. To open the oven door, you will have to wait until the temperature inside it has dropped to a suitable value. You will notice some white dust deposits on the bottom and the sides of your oven; remove them with a damp sponge once the oven has cooled down completely. You may on the other hand prefer to take advantage of the heat accumulated to start cooking immediately; in this case the dust can stay where it is: it is completely harmless and will not affect your food in any way. Warning: to maximise the efficiency and life of the appliance, we recommend that automatic clean is carried out with the hob off. What happens at the end of an automatic cleaning cycle?At the end of the automatic cleaning cycle, the word “end” is displayed and an acoustic signal is sounded, which can be silenced just by pressing any one of the buttons. Turn knob “L” to the “0” setting and the word “end” will disappear. Fast Clean Programming The fast clean cycle time and/or cycle end time can be programmed after selecting the fast clean mode, and within the 10 first minutes of operation. [. . . ] Frånkoppling av Demo Mode Om texten DEMO ON visas på displayen ska du vrida inställningsvredet L till läget 0 och tryck sedan på knapparna i följd från 1 till 6 för att ställa in spisens funktionssätt. Du kan även använda den vid slutfasen vid tillagning av maträtter som behöver en stekyta, den är till exempel idealisk för att ge färg till pastarätter. Fast clean – toimintoon liittyviä lisätietoja varten, katso kappaletta “Automaattinen puhdistus fast clean –toiminnon avulla”. Cooking time = 1h15 and end cooking time set at 12. [. . . ]