User manual BARTSCHER 215037

[. . . ] Always keep this owner’s manual close to hand since you may need to refer to it in the future. 5 When you have removed the packing, check that the appliance is not damaged. If you have any doubts, do not use the appliance and contact your nearest Ariston Service Centre. Never leave the packing components (plastic bags, polystyrene foam, nails, etc. [. . . ] However, these rooms must not be common rooms or bedrooms. Detail A Adjacent Room Room to be Ventilated Installing the Cooker The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. The wall in direct contact with the back panel of the cooker must be made of non-flammable material. During operation the back panel of the cooker could reach a temperature of 50°C above room temperature. For proper installation of the cooker, the following precautions must be taken: a) Kitchen cabinets installed next to the cooker that are higher than the top of the hob, must be at least 200 mm from the edge of the hob itself. B) Hoods must be installed according to the requirements in the installation manual for the hood and, in any case, at a minimum height of 650 mm. C) If the hood is installed below a wall cabinet, the latter must be at least 700 mm (millimetres) above the surface of the hob. Cabinets installed adjacent to the hood must be at least 420 mm above the hob, as shown in Figures C and D. B c) Intensive and prolonged use of the appliance may result in the need for supplemental air circulation, e. Making the Gas Connection The appliance should be connected to the mains or to a gas cylinder in compliance with current National Regulations. Before making the connection, check that the cooker is regulated for the gas supply you are using. Converting the Cooker to Different Types of Gas In order to convert the cooker for use with a type of gas different than the one for which it was factory set (indicated on the label attached to the lid), the following steps must be taken: a) Replace the hose holder mounted on the appliance with that supplied in the bag of “cooker accessories. € Important: The hose holder for liquid gas is marked 8, the hose holder for methane and city gas is marked 13. In any case, always use a new sealing gasket. B) Replace the burner nozzles on the hob: • Remove the grids and slide the burners from their housings; • Unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of gas (see table 1 “Burner and Nozzle Characteristics”). €¢ Replace all the components by repeating the steps in reverse order. C) Minimum regulation of the hob burners: • Turn the tap to minimum; • Remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the flame is small but steady. : In the case of liquid gas, the regulation screw must be screwed in all the way. €¢ Check that the flame does not go out when you turn the tap quickly from high to low. D) Regulating the primary air of the burners: The primary air of the burners does not need to be regulated. To light one of the burners, hold a lighted match or lighter near the burner and, at the same time, press down and turn the corresponding knob in the counter-clockwise direction to the maximum setting. Each burner can be operated at its maximum, minimum or intermediate power. [. . . ] Pastry is too dark on top Place it on a lower rack, lower the temperature, and increase the cooking time. Cooked well on the inside but sticky on the outside Use less liquid, lower the temperature, and increase the cooking time. The pastry sticks to the pan Grease the pan well and sprinkle it with a dusting of flour. I used more than one level and they are not all at the same cooking point Use a lower temperature setting. [. . . ]