User manual BARTSCHER 2856001

[. . . ] The oven accessories that may come into contact with food are made of materials which comply with the provisions set forth by the EEC Directive 89/109 of 21/ 12/88 and by Italian law decree no. After having removed the packaging, check that the appliance is intact. If in doubt, do not use the appliance and contact professionally qualified personnel. Never leave the packing components (plastic bags, foamed polystyrene, nails, etc. [. . . ] tROUBLESHOOTING DO NOT WORRY IF… Some operating anomalies may arise. These are generally due to incorrect handling or to the erroneous assessment of a phenomenon. If your oven releases a lot of smoke during cooking: • Make sure you have selected the correct cooking mode for the type of dish you want to prepare and that you have selected the right accessories and put the dish in the oven at the recommended rack height. € Check the temperature selected: it is no doubt too high for the type of cooking required. 6 • • Check the degree of soil of the oven, and whether the latter needs to be cleaned. Food residue encrusted onto the enamel coating inside the oven becomes charred and creates both smoke and pungent smells. Splashes of grease or overflows onto very hot surfaces could crate smoke. tROUBLESHOOTING DO NOT WORRY IF… Some operating anomalies may arise. Button to set the timer Buttons + and - to set the clock, timer, cooking duration and end-of-operation time, press on: + to increase the time - to reduce the time Setting the time You can only set the time if the mode selector is set to "0". After the appliance has been connected to the power supply (or following a power failure), a flashing "0. Press keys "+" and/or "-" to set the time. You may change the recommended cooking time by pressing and keys "+" and/or "-" (the cooking time must include approximately 10 minutes for the oven to pre-heat). The cooking time is memorised, but you still have another 3 seconds to modify it. During the pre-heating phase, symbol blinks and the cooking time is displayed. When pre-heating is done, symbol stops blinking and the oven emits 3 acoustic beeps. There is no pre-heating phase when using the "fast cooking" and "grill" modes. The amount of time left until cooking is done is displayed during cooking. To see the temperature, press key "+". The minimum programmable cooking time is 2 minutes. The maximum programmable cooking time is 10 hours. Programmed cooking with delayed start The programmer automatically selects the cooking start time according to the parameters you have set: cooking time and end cooking time. To set the cooking time, • press key • set the cooking time by pressing keys "+" and/or "-" (cooking time should include the pre-heating time): The cooking time is memorised, but you still have another 3 seconds to modify it. [. . . ] To install the cable, proceed as follows: • Remove the wire clamp screw and the three contact • screws L-NFasten the wires beneath the screwheads using the following colour scheme: Blue (N) Brown (L) YellowGreen • Secure the supply cable in place with the clamp and close the cover of the terminal board. N L Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. When connecting the cable directly to the mains, install an omnipolar circuit-breaker with a minimum contact opening of 3 mm between the appliance and the mains. The omnipolar circuit breaker should be sized according to the load and should comply with current regulations (the earth wire should not be interrupted by the circuit breaker). [. . . ]