User manual BARTSCHER 601182-213

[. . . ] Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works. 19 Important Information GB For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter. You MUST clean the fluff filter after EVERY drying cycle. Pull out the filter (using the two finger grips). [. . . ] An Automatic programme Wool Dries your Woollen clothes, (see previous page). Dries your clothes on Low heat setting, ready to be worn. Acrylics) q The default is Automatic Airing 20-minute programme that airs your clothes with cool air. Brief programme (approximately 10 minutes) that softens fibres of clothing that is ready for ironing. This is not a drying programme (see previous page). Press and release the Timed button for loads less than 1kg, or until the display shows the required Alarm , Time Delay , if you prefer a different selection. (0:20, 0:40, , , , , , then and 1:00, 1:20, 1:40, then repeats. The heat setting depends q 2:00 or 2:20 Delicates have maximum time of . on the programme Hours:Minutes) GB (material option) selected. Q When is displayed, Automatic option is available if you change your mind. The last 10 minutes of these programmes is the Cool Tumble phase . Q Empty Water Container (If you have plumbed your dryer to a drain this icon can be ignored, as there is no need to empty the water container). Messages are displayed to reminds you to empty the water container. If the water container fills during a programme, the heater turns off and the dryer does a period of Cool Tumble. After this it stops and a message tells you to EMPTY THE WATER CONTAINER . You must empty the water container and restart the dryer or the clothes will not dry. After re-starting the dryer the message will take a few seconds to go out. To avoid this always empty the water container each time you use the dryer (see Maintenance). Q Door Opening q Opening the door during a programme will stop the dryer and have the following effects: q The display shows PAUSED . Q During a delay phase the delay will continue to count down. The Start/Pause button must be pressed to resume the delay programme. the display will change to show current status. [. . . ] This is normal, the: END OF CYCLE, EMPTY THE WATER BOTTLE message is shown as a reminder to empty the container (see The Display and Start and Programmes). Q q q q q q q q q Empty water message is displayed but the dryer has only been running for a short period. Empty water message is displayed and the water container is not full. Programme finishes and clothes are damper than expected. [. . . ]