User manual BARTSCHER 700.950 SCHEMA

[. . . ] 27 Structural support Installation Installation instructions . 31 Electrical connection Technical data 2 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. Read these instructions carefully before installing or using the Ventilation System. Use the appliance only for its intended purpose. , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Use this appliance only in the manner intended by the manufacturer. [. . . ] Level 1 operates at 40% capacity Level 2 operates at 60% capacity Level 3 operates at 80% capacity Level 4 operates at 100% capacity There will also be a slight decrease in airflow for hoods operated in recirculation mode due to the active charcoal filter. ^ To activate the automatic switch back press the "+" button. ^ To deactivate the automatic switch back press the "­" button. ^ To save the setting press the Delayed Shut down button. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. 11 Operation Delayed Shut Down If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. Turning off the fan ^ Press the On/Off button to turn the fan off. The indicator will go out. ^ Press the Delayed Shut Down button while the fan is still running. Press once = 5 minute delay (left indicator lights) Press twice = 15 minute delay (right indicator lights) To cancel the Delayed Shut Down feature press the button again. Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last button was pressed. The lighting however will remain on. ^ Press the On/Off button to turn the fan back on again. 12 Operation Turning the lighting On/Off The overhead lighting can be turned on and off independently from the fan. Dimming the lighting The brightness of the lighting can be adjusted. ­ A time of 20 hours should also be programmed if the kitchen is only used occasionally to prevent grease which has accumulated over a long period of time from hardening on the filters making cleaning more difficult. Reprogramming the grease filter timer The lit indicator shows the programmed time: 1st indicator from the left 2nd indicator from the left 3rd indicator from the left 4th indicator from the left = = = = 20 hours 30 hours 40 hours 50 hours ^ Use the "­/+" button to select the desired time. ^ Save the selection by pressing the grease filter button. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. ^ Press the On/Off button to turn off the fan. ^ Press the Delayed Shut Down and grease filter buttons at the same time. The indicator for the grease filter and one of the "­/+" indicators will flash. 15 Operation Reprogramming the charcoal filter timer The active charcoal filter can only be used in recirculation mode and cannot be used to exhaust fumes. The charcoal filter timer is not preset. ^ After cleaning, the filters can be placed on a towel to air dry. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. When putting the grease filters back make sure that the locking clips are visibly facing the cooking surface. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ After returning the grease filters, press and hold the grease filter button for 3 seconds to reset the timer. ^ If the grease filters are cleaned before the grease filter timer has reached its maximum, press the grease filter button for 6 seconds to reset the counter to zero. The grease filters should be cleaned every 3 - 4 weeks or when the grease filter indicator lights. , A dirty filter is a fire hazard. ^ To remove the grease filters pull the locking clips, 1, forward. Lower the filter 45°, 2, unhook it at the rear, 3, and take it out. Support the grease filter so that it does not fall onto the cooktop. Cleaning the grease filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. They could destroy the filter. 18 Cleaning and Care Active charcoal filter In recirculation mode an active charcoal filter must be used in addition to the grease filters. [. . . ] See "Cleaning and Care" and "Operation". Installation accessories 4 Screws 8 x 60 mm with 4 Washers (S10 wall anchors included in the packaging are not for use in USA / CDN) 2 spring clips to hang the hood onto the mounting plate , CAUTION To avoid risk of hand or other injury, avoid contact with sharp edges during the assembly and installation process. 29 Air extraction , WARNING Danger of toxic fumes. Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Do not vent exhaust air into spaces within walls or ceilings or in attics, crawl spaces or garages. [. . . ]