User manual BARTSCHER 700201G

[. . . ] Keep this instruction manual ready to hand at the product!This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device. In addition to the information given here, you should comply with any local Health and safety Controls and generally applicable safety regulations. [. . . ] In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. 1 Overview of parts Air suction Air outlet Grids Glass doors Air is sucked in and cold air is circulated inside the Refrigerated showcase. Let inside circulating cold air flow out. The sliding glass doors at the rear allow for comfortable removal and insertion of beverages and foodstuffs. The device must only be connected to a properly installed single socket with protective contact. Never yank cord to disconnect from outlet. See that the cable does not touch any heat sources or sharp edges. do not let the cable dangle over the counter edge. Do not use the device if it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user, or lead to damage of the device or personal injury, and furthermore invalidate the warranty. Do not lay the cable over carpets or heat insulations. Keep the cable away from operating range and do not dunk it into water. Avoid water splashes on the refrigerated showcase and do not expose the device to rain water, dripping water or any other kind of moisture. Before installation, the local power grid specification should be compared with that of the device (see type label). connect the device only in case of compliance!Discard the complete packing material after unpacking the device. Place the device on top of an even and safe surface which supports the weight of the device. Not at any time should you place the device on an inflammable surface (such as: table cloth, carpet, etc. [. . . ] In order to guarantee the cooling effect a sufficient air stream must develop. The stored foods should have sufficient interspaces to each other. non-sufficient distances may result affect the cooling performance. The heights and distances of the grids should be chosen according to the heights of the foods and beverages. [. . . ]