User manual BARTSCHER 900002

[. . . ] This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device. In addition to the information given here, you should comply with any local Health and safety Controls and generally applicable safety regulations. The instruction manual forms part of the product and should be kept near the device and easily accessible for anyone carrying out the installation, servicing, maintenance or cleaning. [. . . ] In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. Stainless steel inside and outside adjusted, 35° ­ 60°C 230 V 50 Hz 200 W Subject to technical changes and alterations!The device must only be connected to a properly installed single socket with protective contact. Never yank cord to disconnect from outlet. See that the cable does not touch any heat sources or sharp edges. During operation some parts of the device become very hot. In order to avoid injuries do not touch any hot parts!Do not use the device if it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user, or lead to damage of the device or personal injury, and furthermore invalidate the warranty. Do not lay the cable over carpets or heat insulations. Keep the cable away from operating range and do not dunk it into water. When the unit is in use, never touch the spiral screws or any other moving parts. Do not move or tilt the device when in operation. Before installation, the local power grid specification should be compared with that of the device (see type label). connect the device only in case of compliance!Clean the worm screw (2), the tower (3), the top (3a) and the lower bowl (4) with washing liquid and rinse them with clean water and then dry them. Install the lower bowl (4) and then the worm screw (2). Not at any time should you place the device on an inflammable surface (such as: table cloth, carpet, etc. You must not position the device near open fireplaces, electric ovens/arc furnaces, furnaces/electric heaters or other heat sources. Make sure that the wire is unavailable to children and is not an obstacle which can lead to stumbling. Position the device in such a way that the plug is easily accessible. [. . . ] Do not pour the needless amount of chocolate out to the sink or to the toilet (danger of blocking pipes!Activate the (6) " MOTOR ON/OFF" switch (the worm screw will be turned off). Disconnect the device from the power supply (take out the plug!Slightly sour fruit should be served with sweet chocolate and sweet fruit with bitter chocolate. [. . . ]