User manual BARTSCHER A100.265 SCHEMA

[. . . ] Keep these instructions at the place where you can find it easily. If you are unsure of any of the information contained in these instructions, please contact the SamSung customer care center. These instructions are only valid for the countries of destination, the identification symbols of which are indicated on the cover of the instruction manual. The manufacturer shall not be held responsible for any damages to persons or property caused by incorrect installation or use of the appliance. [. . . ] Do not use excessive weight and do not hit the hob with heavy objects. 260mm 180mm 120mm User can't use cooking pan on the appliance that overlap its edge. Cleaning and Maintenance Cleaning operations must only be carried out when the appliance is cool. The appliance should be disconnected from your mains supply before commencing any cleaning process. Clean the appliance regularly, preferably after each use. Abrasive cleaners or sharp objects will damage the appliance surface;you should clean it using water and a little washing up liquid. YES Always use cookware that are suitable for each burner, so as to avoid wasting gas and discolouring the cookware. Only use pots, saucepans and frying pans with thick, flat bottom. Always place the cookware right over the burners, not to one side. Gently wipe the Ignition device and flame supervision device with a well wrung-out cloth and wipe dry with a clean cloth. Before placing the burners back on the top plate, make sure that the injector is not blocked. Troubleshooting Repairs to the gas and electrical components of this appliance must only be carried out by a suitably qualified and competent person to ensure safety. However, some minor problems can be resolved as follows : Problem Not ignited Probable cause No Spark. Badly ignited The gas supply is incompletely opened. Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible. The adjustment conditions for this appliance are stated on the label (or data plate). This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilaton. Before installing, turn off the gas and electricity supply to the appliance. All appliances containing any electrical components must be earthed. Ensure that the gas pipe and electrical cable are installed in such a way that they do not touch any parts of the appliacne which become hot. Gas pipe or connector shouldn't be bent or blocked by any other appliances. Check the dimensions of the appliance as well as the dimensions of the gap to be cut in the kitchen unit. The panels located above the work surface, directly next to the appliance, must be made of non-flammable material. [. . . ] Fit regulator(natural gas) or propane fitting(LPG) directly to the elbow(1/2" tapered thread). Direction of gas flow is indicated on the rear of the regulator. The inlet of the regulator is a 1/2" parallel thread and is connected to consumer piping or flexible hose. LPG connection Natural gas connection 70mm 36mm (C) SCREW (B) BRACKET Elbow 1/2" Taperd thread Pressure test poine 1/2" parallel thread outlet Sealing washer Regulator Elbow 1/2" Taperd thread Pressure test poine H H A duplicate data label is supplied for adhesion to an accessible location near the appliance if the data label on the base of the appliance cannot be accessed when the appliance is installed. inlet H H All the fitting thread must use pipe compound or thread sealant. [. . . ]