User manual BARTSCHER A150.052 PARTS LIST

[. . . ] 8 Without the mounting bracket in place: . Install the dishwasher under the countertop . 33 2 IMPORTANT SAFETY INSTRUCTIONS Installation Installation, maintenance and repair work should be by a Miele authorized service technician. Work by unqualified persons could be a hazard and may void the warranty. [. . . ] This will allow the machine to slide easier, protect the floor, and allow adjustment of the rear leveling legs from the front of the unit. ^ First, adjust the height of the legs so that the top of the dishwasher is roughly 1/8" (3 mm) below the countertop. Tipping the machine slightly to the rear, if possible, will make adjusting the front legs easier. Make sure the machine is level when adjustments are complete. ^ Insert the tab of each bracket into the guide holes on top. Stone or marble counterops: Do not install these mounting brackets if the counter is made of an extremely hard material. The securing screws for the mounting brackets are not suitable for such materials. ^ Place the skis, with the ratchet at the rear, under the dishwasher legs. 14 Installation 4. Install the dishwasher under the countertop The dishwasher must be installed so that the water and electricity supplies can be accessed through an adjacent cabinet. The supplies must not be located behind the machine. ^ Make certain that there are no rough edges that could damage the power cord or hoses. If metal cabinets are used, place the supplied rubber grommet around the edge of the opening before passing the cable through. , WARNING - Fire hazard Do not cover or crush the plug of an electric appliance. Ensure that the cabinet opening for the dishwasher provides ample space for the plug. Adjust and secure the front panel Once installed, the panel can be raised or lowered up to 1/16" (2 mm) to match the cabinet lines. ^ Once this side of the panel lines up with the cabinets, secure it by tightening the upper screw on the edge of the dishwasher door. ^ Repeat the process with the other side of the panel. ^ Insert the supplied end caps into the four screw holes. Adjust one side of the door panel at a time using a T20 Torx screwdriver. Do not use a power screwdriver to adjust or secure the decorative panel to the dishwasher. ^ If the upper screws on the edge of the door are not loose, loosen them slightly. ^ The panel can be raised or lowered by turning the lower screw on each side of the dishwasher door. To lower the panel turn counterclockwise. 22 Installation 8. Secure the dishwasher ^ Open the dishwasher door. If the steam deflector is installed, the mounting bracket holes must align with the slots in the steam deflector. Make certain that the white rubber seal located at the top, outer edge of the dishwasher is tight against the bottom of the countertop. [. . . ] Permanent Connection (Hard Wiring) For hard wiring, the power cord must be disconnected from the terminal box located at the lower left front of the dishwasher, behind the toekick and service panel. Pass the permanent power supply cable through the strain relief and secure it to the terminal box. Connect: L1 N (Black) to L on terminal block (White) to N on terminal block GRND To ground connector GROUNDING INSTRUCTIONS This appliance must be connected to a grounded metal, permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead on the appliance. Use copper conductors only. , Hardwiring the dishwasher should only be done if required by local electrical codes, and then in accordance with those codes. Do not cut the plug off the power supply cord and connect it directly to the house wiring. 31 Installation 12. [. . . ]