User manual BARTSCHER A151600

[. . . ] • The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode. • The fan speed and temperature setting are set to AUTO. TO TURN ON HOW TO USE THE REMOTE CONTROL Point the remote control towards the unit’s signal receiver window and press the desired button. The unit generates a beep when it receives the signal. [. . . ] • The remote control can send signals from up to 7 metres away. TO TURN OFF Press the AUX button again. • The red OPERATION lamp ( turn off. ) on the unit will AUX NOTE: • If the AUX button is pressed during normal operation, the unit will turn off. GB- A151600_GB. indd 4 11. 9. 30 5:02:54 PM BASIC OPERATION MODE 1 Press themode. button to select the operation AUTO HEAT COOL DRY ENGLISH 2 5 3 1 4 2 Press the ON/OFF button to start operation. • The red OPERATION lamp ( will light. ) on the unit 3 Press the THERMOSTAT button to set the desired temperature. AUTO/DRY MODE • The temperature can be changed up to 2°C above or below the temperature automatically determined by the air conditioner. COOL/HEAT MODE • The temperature can be set within the range of 18 to 32°C. TIPS ABOUT AUTO MODE In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. Modes and Temperature Settings Room temp. at operation start-up Below 21˚C 21˚C-24˚C 24˚C-26˚C 26˚C-28˚C Above 28˚C Mode Automatic Operation Temperature Setting 23˚C Room Temp. -2˚C 24˚C 25˚C 26˚C 4 Press the FAN button to set the desired fan speed. AUTO SOFT LOW HIGH HEAT DRY COOL COOL COOL • In the DRY mode, the fan speed is preset to AUTO and cannot be changed. off the 5 To turnagain. unit, press the ON/OFF button • The red OPERATION lamp ( will turn off. ) on the unit GB- A151600_GB. indd 5 11. 9. 30 5:02:55 PM ADJUSTING THE AIR FLOW DIRECTION VERTICAL AIR FLOW DIRECTION HORIZONTAL AIR FLOW DIRECTION Adjust the horizontal air flow direction with the louver lever. 1 Press the SWING button. • The vertical adjustment louvre will swing continuously. the 2 Press the SWING button again when the vertical adjustment louvre comes at desired position. 1 2 CAUTION: Adjustment range COOL and DRY modes HEAT mode Louvre levers Never attempt to adjust the vertical adjustment louvre manually. • Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction. • When the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. • The red OPERATION lamp ( ) and the orange TIMER lamp ( ) on the unit will turn off. • The ONE-HOUR OFF TIMER operation has priority over TIMER ON and TIMER OFF operations. • If the ONE-HOUR OFF TIMER is set while the unit is not operating, the unit starts one-hour operation at the formerly set condition. • If you wish to operate the unit for another hour before the ONE-HOUR OFF TIMER is activated, press the ONE-HOUR OFF TIMER button again during operation. NOTE: GB- A151600_GB. indd 8 11. 9. 30 5:02:56 PM TIMER OPERATION TIMER OFF the OFF ( 1 Pressset theTIMERas desired. and time ) button TIMER ON ENGLISH • The time setting will change as you press the button as follows. Hold the button down to speed through the settings. 1 Press the TIMERasON ( and set the time desired. ) button • The time setting will change as you press the button as follows. Hold the button down to speed through the setting. ) on the unit • The orange TIMER lamp ( will light. • The time setting will count down to show the remaining time. ) on the unit • The orange TIMER lamp ( will light. • The time setting will count down to show the remaining time. 1 1 CANCEL Select the mode, temperature and fan speed setting as desired. • When the temperature is set with the TIMER ON, the temperature will show in the display for 5 seconds and then return to the time display. [. . . ] • The unit will turn on prior to the set time to allow the room to reach the desired temperature by the programmed time. (Awaking function) CANCEL TO CANCEL Press the CANCEL button. • The orange TIMER lamp ( turn off. ) on the unit will TO CANCEL TIPS ABOUT TIMER OFF OPERATION Press the CANCEL button. [. . . ]