User manual BARTSCHER A190.043 V6-1010

[. . . ] Coffee machine from page 19 to 35 GB/UK Keep this instruction manual ready to hand at the product!This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device. In addition to the information given here, you should comply with any local Health and safety Controls and generally applicable safety regulations. [. . . ] Never yank cord to disconnect from outlet. See that the cable does not touch any heat sources or sharp edges. do not let the cable dangle over the counter edge. Never fill hot water into the cold water tank. Do not fill water into the hot device; wait until it has cooled down. During operation some elements of the device very become hot. Do not use the device in case it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user or lead to damages of the device or personal injury, and further, the warranty expires. Do not lay the cable over carpets or heat insulations. Keep away the cable from operating range and do not dunk it into water. Do not move or tilt the device when in operation. Before installation the local power grid specification should be compared with that of the device (see type label). connect the device only in case of compliance!Discard the complete packing material after unpacking the device. Place the device on top of an even and safe surface which supports the weight of the device and is not heat sensitive. Not at any time should you place the device on an inflammable surface (such as: table cloth, carpet, etc. You must not position the device near open fireplaces, electric ovens/arc furnaces, furnaces/electric heaters or other heat sources. The electrical circuit in the socket must be secured to at least 16A. Only connect the device directly to the wall socket; do not use any extension cords or power strips. Place the device so that the plug is easily accessible and can be quickly removed from its socket in case of necessity. Prior to first use, run 2 to 3 portions of water without coffee through the coffee machine in order to rinse the device (, , Brewing coffee", steps 1-8). [. . . ] In order to remove these residues follow the steps below: 1. Leave this solution in the thermo jug for about 20 minutes and pour it out afterwards. Rinse the thermo jug thoroughly and wipe it dry using a dry, soft cloth. Do not use any kind of abrasive agents as this could cause scratches which could again result in cracks. [. . . ]