User manual BARTSCHER A300302-125

[. . . ] No part of this manual may be reproduced, copied, translated, transmitted, or published in any form or by any means without BARTSCHER's prior written permission. „„ In order to assist in the use of this product, carefully read the User's Manual. „„ For product-related information, check on our website at: http://www. gigabyte. com Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X. X. " For example, "REV: 1. 0" means the revision of the motherboard is 1. 0. Check your motherboard revision before updating motherboard BIOS, drivers, or when looking for technical information. [. . . ] Profile2 (Note 2) Uses Profile 2 settings.  Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD data. (Default: Auto) The first memory frequency value is the normal operating frequency of the memory being used; the second is the memory frequency that is automatically adjusted according to the System Memory Multiplier settings. && Extreme Memory Profile (X. M. P. ) (Note 2) && System Memory Multiplier && Memory Frequency (MHz) `` Advanced Memory Settings &&  xtreme Memory Profile (X. M. P. ) (Note 2), System Memory Multiplier, Memory Frequency(MHz) E && Performance Enhance The settings above are synchronous to those under the same items on the Advanced Frequency Settings menu. Allows the system to operate at three different performance levels. Normal  Lets the system operate at its basic performance level. Turbo  Lets the system operate at its good performance level. (Default) Extreme  Lets the system operate at its best performance level. && DRAM Timing Selectable && Profile DDR Voltage Quick and Expert allows the Channel Interleaving, Rank Interleaving, and memory timing settings below to be configurable. Options are: Auto (default), Quick, Expert. When using a non-XMP memory module or Extreme Memory Profile (X. M. P. ) is set to Disabled, this item will display as 1. 50V. When Extreme Memory Profile (X. M. P. ) is set to Profile1 or Profile2, this item will display the value based on the SPD data on the XMP memory. Check the fan condition or fan connection when this occurs. (Default: Disabled) Allows you to determine whether to enable the CPU fan speed control function and adjust the fan speed. Normal   Allows the CPU fan to run at different speeds according to the CPU temperature. You can adjust the fan speed with EasyTune based on your system requirements. (Default) Silent  Allows the CPU fan to run at slow speeds. Manual  Allows you to control the CPU fan speed under the Slope PWM item. Disabled  Allows the CPU fan to run at full speeds. && Slope PWM Allows you to control the CPU fan speed. This item is configurable only when CPU Fan Speed Control is set to Manual. Options are: 0. 75 PWM value /oC ~ 2. 50 PWM value /oC. - 19 - && System Fan Speed Control && Slope PWM Allows you to determine whether to enable the system fan speed control function and adjust the fan speed. Normal   Allows the system fan to run at different speeds according to the system temperature. You can adjust the fan speed with EasyTune based on your system requirements. [. . . ] You can create up to 8 profiles and save as Setup Profile 1~ Setup Profile 8. Or you can select Select File in HDD/USB/FDD to save the profile to your storage device. If your system becomes unstable and you have loaded the BIOS default settings, you can use this function to load the BIOS settings from a profile created before, without the hassles of reconfiguring the BIOS settings. First select the profile you wish to load and then press <Enter> to complete. [. . . ]