User manual BARTSCHER A300313-127

[. . . ] No part of this manual may be reproduced, copied, translated, transmitted, or published in any form or by any means without BARTSCHER's prior written permission. „„ In order to assist in the use of this product, carefully read the User's Manual. „„ For product-related information, check on our website at: http://www. gigabyte. com Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X. X. " For example, "REV: 1. 0" means the revision of the motherboard is 1. 0. Check your motherboard revision before updating motherboard BIOS, drivers, or when looking for technical information. [. . . ] (Default: Auto) This value is automatically adjusted according to the BCLK/PCIe Clock Control and System Memory Multiplier settings. && Memory Frequency (MHz) `` Advanced Memory Settings && Extreme Memory Profile (X. M. P. ) (Note), System Memory Multiplier, Memory Frequency(MHz) && DRAM Timing Selectable The settings above are synchronous to those under the same items on the Advanced Frequency Settings menu. && Profile DDR Voltage Quick and Expert allows the memory timing settings below to be configurable. Options are: Auto (default), Quick, Expert. When using a non-XMP memory module or Extreme Memory Profile (X. M. P. ) is set to Disabled, this item will display as 1. 50V. When Extreme Memory Profile (X. M. P. ) is set to Profile1 or Profile2, this item will display the value based on the SPD data on the XMP memory. The value displayed here is dependent on the CPU being used. && Profile VTT Voltage && Channel Interleaving Enables or disables memory channel interleaving. Enabled allows the system to simultaneously access different channels of the memory to increase memory performance and stability. Auto lets the BIOS automatically configure this setting. (Default: Auto) This item is present only when you install a memory module that supports this feature. - 27 - (Note) && Rank Interleaving Enables or disables memory rank interleaving. Enabled allows the system to simultaneously access different ranks of the memory to increase memory performance and stability. Auto lets the BIOS automatically configure this setting. Manual Allows you to control the CPU fan speed under the Slope PWM item.  Disabled Allows the CPU fan to run at full speeds.  Allows you to control the CPU fan speed. This item is configurable only when CPU Fan Speed Control is set to Manual. Options are: 0. 75 PWM value /oC ~ 2. 50 PWM value /oC. Allows you to determine whether to enable the system fan speed control function and adjust the fan speed. Normal   Allows the system fan to run at different speeds according to the system temperature. You can adjust the fan speed with EasyTune based on your system requirements. (Default) Silent  Allows the system fan to run at slow speeds. Manual Allows you to control the system fan speed under the Slope PWM item.  Disabled Allows the system fan to run at full speeds. [. . . ] To copy the RAID/AHCI driver for Windows XP, copy all files in the \BootDrv\Hxp folder in the motherboard driver disk to your floppy disk. To install Windows 7/Vista, you also need to install the SATA RAID/AHCI driver during the OS installation. To copy the RAID/AHCI driver for Windows 7, copy the whole Hw7 folder under the BootDrv folder in the motherboard driver disk to a USB flash drive. Installing the SATA RAID/AHCI Driver and Operating System A. Installing Windows XP Restart your system to boot from the Windows XP setup disk and press <F6> as soon as you see the message "Press F6 if you need to install a 3rd party SCSI or RAID driver. " Insert the floppy disk containing the SATA RAID/AHCI driver. [. . . ]