User manual BARTSCHER A370031

[. . . ] No part of this manual may be reproduced, copied, translated, transmitted, or published in any form or by any means without BARTSCHER's prior written permission. „„ In order to assist in the use of this product, carefully read the User's Manual. „„ For product-related information, check on our website at: http://www. gigabyte. com Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X. X. " For example, "REV: 1. 0" means the revision of the motherboard is 1. 0. Check your motherboard revision before updating motherboard BIOS, drivers, or when looking for technical information. [. . . ] Auto sets memory multiplier according to memory SPD data. (Default: Auto) && Memory Frequency (MHz) This value is automatically adjusted according to the BCLK Clock Control and System Memory Multiplier settings. `` Advanced Memory Settings && Extreme Memory Profile (X. M. P. ) (Note 2), System Memory Multiplier, Memory Frequency(Mhz) The settings above are synchronous to those under the same items on the Advanced Frequency Settings menu. (Note 1) This item is present only when you install a CPU that supports this feature. (Note 2) This item is present only when you install a memory module that supports this feature. - 25 - && Performance Enhance && DRAM Timing Selectable Allows the system to operate at three different performance levels. Normal  Lets the system operate at its basic performance level. Turbo  Lets the system operate at its good performance level. (Default) Extreme  Lets the system operate at its best performance level. Quick and Expert allows the memory timing settings below to be configurable. Options are: Auto (default), Quick, Expert. When using a non-XMP memory module or Extreme Memory Profile (X. M. P. ) is set to Disabled, this item will display as 1. 50V.  PWM  Sets PWM mode for a 4-pin CPU fan. - 28 - && CPU Fan Speed Control && Slope PWM Allows you to determine whether to enable the CPU fan speed control function and adjust the fan speed. Normal   Allows the CPU fan to run at different speeds according to the CPU temperature. You can adjust the fan speed with EasyTune based on your system requirements. (Default) Silent  Allows the CPU fan to run at slow speeds. Manual Allows you to control the CPU fan speed under the Slope PWM item.  Disabled Allows the CPU fan to run at full speeds.  Allows you to control the CPU fan speed. This item is configurable only when CPU Fan Speed Control is set to Manual. Options are: 0. 75 PWM value /oC ~ 2. 50 PWM value /oC. Allows you to determine whether to enable the system fan speed control function for the system fan connected to the SYS_FAN1 connector and adjust the fan speed. Normal   Allows the system fan to run at different speeds according to the system temperature. [. . . ] 9. Press <Esc> to return to Main Menu and press <Esc> again if you want to exit the RAID BIOS utility. Making a SATA RAID/AHCI Driver Diskette Before installing Windows XP, connect a USB floppy disk drive to your computer first because you need to install the SATA RAID/AHCI driver from a floppy disk that contains the driver during the OS installation. To copy the RAID/AHCI driver for Windows XP, copy all files in the \BootDrv\Hxp folder in the motherboard driver disk to your floppy disk. To install Windows 7/Vista, you also need to install the SATA RAID/AHCI driver during the OS installation. To copy the RAID/AHCI driver for Windows 7, copy the whole Hw7 folder under the BootDrv folder in the motherboard driver disk to a USB flash drive. Installing the SATA RAID/AHCI Driver and Operating System A. [. . . ]