User manual BAUKNECHT G7CG3665XS INSTALLATION

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] if cabinet has a drawer , a 4" (10. 2 cm) depth clearance from the countertop to the top of the drawer (or other obstruction) in base cabinet is required. The drawer depth may need to be shortened to avoid interfering with the regulator. IMPORTANT: If an undercounter built-in wall oven is to be installed below this cooktop, the grounded outlet (H) and gas supply piping must be located in an adjacent cabinet. This cooktop and its gas and electrical supply sources must be installed before the undercounter built-in wall oven is installed. Failure to follow these instructions can result in death, fire, or electrical shock. IMPORTANT: The cooktop must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575 A 120 volt, 60 Hz, AC only, 15-amp, fused electrical circuit is required. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. examples of a qualified person include: licensed heating personnel , authorized gas company personnel , and authorized service personnel. Failure to do so can result in death, explosion, or fire. observe all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223. 1 - latest edition or CAN/CGA B149 - latest edition. IMPORTANT: Leak testing of the cooktop must be conducted according to the manufacturer's instructions. Natural Gas: This cooktop is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas. This cooktop is factory set for use with Natural gas. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP Gas Conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the cooktop from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. [. . . ] Avoid drilling into or severing existing wiring during installation. Clamping brackets can be installed on the front and back of cooktop base bottom, if necessary. Clamping bracket (extends far enough beyond cooktop base to allow installation of clamping screws) E. NOTE: There will be a small gap (approximately ¹/" [3 mm]) between the cooktop and the countertop. [. . . ]