User manual BAUKNECHT GX5FHTXVY

[. . . ] If you should experience a problem not covered in TROUBLESHOOTING, please visit our website at www. If you still need assistance, call us at 1-800-253-1301. You will need your model and serial number, located on the inside wall of the refrigerator compartment. Your safety and the safety of others are very important. [. . . ] When the left side door is opened, the hinged seal automatically folds inward so that it is out of the way. NOTE: Adjusting the refrigerator and freezer temperature controls to a colder than recommended setting will not cool the compartments any faster. If the temperature is too warm or too cold in the refrigerator or freezer, first check the air vents to be sure they are not blocked before adjusting the controls. Style 1 Press the freezer down arrow touch pad until a dash (-) appears in both the refrigerator and freezer displays. Neither compartment will cool when the freezer is set to OFF. When both doors are closed, the hinged seal automatically forms a seal between the two doors. Use in humid environments or when you notice moisture on the door hinge seal. The refrigerator uses more energy when Humidity Control is on. Press the control to ON when the environment is warm and more humid, or if you notice moisture on the door hinge seal. Press the control to OFF to save energy when the environment is less humid. The temperature controls are located at the top front of the refrigerator or freezer compartments. Temperature Controls For your convenience, the temperature controls are preset at the factory. When you first install your refrigerator, make sure the controls are still set to the recommended setting as shown. If you need to adjust the temperature in either the refrigerator or freezer compartment, use the settings listed in the chart below as a guide. For (Style 1) controls press the up or down arrow touch pads, or for (Style 2) controls turn the dial to adjust the temperature. Except when starting the refrigerator, do not adjust either control more than one setting at a time. Wait 24 hours between adjustments for the temperature to stabilize. CONDITION/REASON: REFRIGERATOR too warm FREEZER too warm/too little ice REFRIGERATOR too cold ADJUSTMENT: REFRIGERATOR Control one setting higher FREEZER Control one setting higher REFRIGERATOR Control one setting lower FREEZER Control one setting lower IMPORTANT: The recommended setting should be correct for normal household refrigerator use. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm. Depending on your model, adjust the control to any setting between FRUIT and VEGETABLES or LOW and HIGH. Wait 24 hours for your refrigerator to cool completely before adding food. If you add food before the refrigerator has cooled completely, your food may spoil. [. . . ] Replacement parts or repair labor if this major appliance is used for other than normal, single-family household use or when it is used in a manner that is inconsistent to published user or operator instructions and/or installation instructions. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. Service calls to repair or replace appliance light bulbs, air filters or water filters. Consumable parts are excluded from warranty coverage. [. . . ]