User manual BAUKNECHT LTG5243DQ DIMENSION GUIDE

[. . . ] ® 24" (61 cm) Gas Washer/Dryer PRODUCT DIMENSIONS 15 3/8 " (39. 1 cm) PRODUCT MODEL NUMBER LTG5243D Gas supply: This washer/dryer is equipped for use with Natural gas. It is design-certified by CSA International for LP (propane or butane) gases with appropriate conversion. Gas supply line must include 1/8" NPT minimum plugged tapping accessible for test gauge connection, immediately upstream of the gas supply connection to the dryer. [. . . ] A time-delay fuse or circuit breaker is recommended. It is also recommended that a separate circuit serving only this appliance be provided. Exhaust venting: Exhaust your dryer to the outside. 4" (10. 2 cm) heavy metal exhaust vent and clamps must be used. DURASAFETM venting products are recommended. Exhaust outlet hood must be at least 12" (30. 5 cm) from the ground or any object that may be in the path of the exhaust. ®TEFLON is a registered trademark of E. I. Du Pont De Nemours and Company. 71 ¾" (182. 2 cm) * Most installations require a minimum 5" (12. 7 cm) clearance behind the dryer for the exhaust vent with elbow. 32 1/8 " (81. 6 cm) *27 ¼" (69. 2 cm) 23 7/8 " (60. 6 cm) RECESSED AREA AND CLOSET INSTALLATION For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. 1" (2. 5 cm) 48 in. 2 (310 cm2) 3" (7. 6 cm) EXHAUST VENTING Select the route that will provide the straightest and most direct path outdoors. Plan the installation to use the fewest number of elbows and turns. Do not use vent runs longer than specified in vent length chart. Determine the number of elbows 2 you will need. 4" (10. 2 cm) 24 in. 2 (155 cm2) 1" (2. 5 cm) 23 7/8" (60. 6 cm) 1" (2. 5 cm) 1"* 27¼" (2. 5 cm) (69. 2 cm) 5"** (12. 7 cm) 3" (7. 6 cm) A B A. Closet door with vents C 1 4" (10. 2 cm) 4" (10. 2 cm) *Required spacing **Rear clearance may be 0" (0 cm) when house exhaust system is lined up directly with dryer exhaust. (6. 4 cm) Angled hood style DRAIN SYSTEM Standpipe drain system - wall or floor The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The minimum carry-away capacity can be no less than 17 gal. A 2" (5 cm) diameter to 1" (2. 5 cm) diameter standpipe adapter kit is available. [. . . ] To determine maximum exhaust length, add one 90° turn to the chart. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. [. . . ]