User manual BAUKNECHT TRKD 6625

[. . . ] Do not use extension leads or multiple adaptors. Before any maintenance on the dryer disconnect it from the mains supply. Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians. [. . . ] When drying cotton, for example: dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. · 4. General recommendations: · Always set the programme/ time selector knob to the "0" position after use. This prevents the dryer from being switched on accidentally. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. Wipe away lint from the door seal and the door using a damp cloth. If the lint filter mesh is clogged, clean it with water and a soft brush. Since lint can go through the filter it is necessary to clean, from time to time, the complete filter area (including below the filter) with a brush, a damp cloth or with a vacuum cleaner. If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. The dryer must only be used in the household for the prescribed uses. · · · · · · · · · · · · · 14 Description of the Dryer A. Door: To open the door: pull the handle. To close the door: push gently until closed. Only comes on when door is open (the programme / time has to be selected). Light off: set the programme/time selector knob to "0" position, or press the option button. A B I F E G H D C E. I. Reminder - Maintenance and Cleaning Filter Clean the lint filter at the end of every drying cycle. Open the door Pull the filter upwards Open the filter Remove lint using a soft brush or your fingertips Close the filter Push the filter back into place. Heat exchanger Clean the heat exchanger at least every 3 months (See "CONDENSER" chapter). How to clean the heat exchanger see separate chapter. Wipe away any lint/fluff from the door seal and interior using a damp cloth. 15 Drainage System For water container top only To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: if the drain hose is not supplied, the optional accessory AMH 883 kit, available at your dealer, should be used. The connection for direct draining is at the rear of the dryer. Place an absorbent cloth underneath to collect water spillage. [. . . ] Please specify: · · · The nature of the fault. The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open. Your full address and phone number. Water droplets underneath the dryer: · · · · Is the heat exchanger correctly positioned?Has any fluff on the heat exchanger seal been wiped away? [. . . ]