User manual BAUKNECHT UXI1200DY INSTALLATION

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] Aluminum/copper connection must conform with local codes and industry accepted wiring practices. The following example falls within the maximum recommended vent length. Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Before making cutouts, make sure there is proper clearance within the ceiling or wall for the exhaust vent. When cutting or drilling into the ceiling or wall, do not damage electrical wiring or other hidden utilities. Check that all installation parts have been removed from the shipping carton. Pull the spring clip to release the blower motor assembly. Remove the blower motor assembly from the housing and place it on a covered surface. Determine which venting method to use: roof or wall exhaust. Excessive Weight Hazard Use two or more people to move and install range hood. Failure to do so can result in back or other injury. Using 2 or more people, move the in-line blower motor system to the mounting location. The in-line blower system must be fastened to a secure structure of the roof, ceiling, wall, floor, or new or existing frame construction. The 4 holes on either the inlet (bottom) side or the outlet (top) side of the blower must be used to mount the in-line blower system to the structure. Plywood may be used to span open areas between ceiling joists or roof rafters to aid installation. This structure must be strong enough to support the weight of the in-line blower system (50 lb [22. NOTE: The blower motor housing can be mounted using 4 holes from either the inlet side or the outlet side of the blower. Remove the 10 screws from the front cover of the in-line blower motor housing and set them aside. NOTE: To make the in-line blower motor housing easier to mount, the blower motor assembly can be removed. If you do not want to remove the blower motor assembly, proceed to the "Installation of the In-line Blower System" section. Determine and make all necessary cuts for the vent system. [. . . ] To locate factory specified replacement parts in your area, call us or your nearest designated service center. Our consultants provide assistance with: Features and specifications on our full line of appliances. Whirlpool Canada LP designated service technicians are trained to fulfill the product warranty and provide after-warranty service, anywhere in Canada. Features and specifications on our full line of appliances. [. . . ]