User manual BAUKNECHT WET3300SQ DIMENSION GUIDE

[. . . ] ® 27" (69 cm) Electric Washer/Dryer PRODUCT DIMENSIONS PRODUCT MODEL NUMBER WET3300S Electrical: A three- or four-wire, single-phase, 120/240-volt, 60-Hz, AC-only electrical supply (or three- or four-wire, 120/208-volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line must be provided. A time-delay fuse or circuit breaker is recommended. [. . . ] The dryer can be converted to exhaust out right or left side. 71/" (181. 9 cm) 23³/" (60. 3 cm) 32¹/" (81. 9 cm) * Most installations require a minimum 5" (12. 7 cm) clearance behind the dryer for the exhaust vent with elbow. *32" (81. 3 cm) 27" (68. 6 cm) RECESSED AREA AND CLOSET INSTALLATION For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. 6" (15. 2 cm) 3" (7. 6 cm) EXHAUST VENTING Select the route that will provide the straightest and most direct path outdoors. Plan the installation to use the fewest number of elbows and turns. Do not use vent runs longer than specified in vent length chart. Determine the number of elbows you will need. Recommended hood styles B 48 in. 2 (310 cm2) 24 in. 2 (155 cm2) 27" 1" 1" (2. 5 cm) (68. 6 cm) (2. 5 cm) 5"** 1"* 32" (2. 5 cm) (81. 3 cm) (12. 7 cm) 3" (7. 6 cm) A Angled hood style is acceptable. B A. Closet door with vents C A 4" (10. 2 cm) 4" (10. 2 cm) 4" (10. 2 cm) 2. 5" (6. 4 cm) * Required spacing ** Rear clearance may be 1" (2. 5 cm) when house exhaust system is lined up directly with dryer exhaust. A. of 90° turns or elbows 0 1 2 Type of Vent Box or Louvered hoods 37 ft (11. 3 m) 32 ft (9. 7 m) 24 ft (7. 3 m) Angled hoods 35 ft (10. 7 m) 27 ft (8. 2 m) 19 ft (5. 8 m) DRAIN SYSTEM Standpipe drain system - wall or floor The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The minimum carry-away capacity can be no less than 17 gal. A 2" (5 cm) diameter to 1" (2. 5 cm) diameter standpipe adapter kit is available. The top of the standpipe must be at least 39" (99 cm) high and no higher than 96" (2. 4 m) from the bottom of the washer. Laundry tub drain system The laundry tub needs a minimum 20 gal. [. . . ] For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. [. . . ]