User manual BDI ALCOVE 8200 CH ASSEMBLY

[. . . ] Placement and Maintenance AlcoveTM Home Theater Furniture is designed for indoor use on level floors. Clean steel parts and wood veneer with a moist cloth. Component List Unpack and identify the parts listed. The assembly workspace should be a non-marring surface such as carpet. [. . . ] Designed to allow passage of wire connections and then grommet drops into place. Position 1" thick Styrofoam from original packaging on top of cabinet to protect it during assembly and installation of TV. Step 6 Install Flat Panel TV using Plasma Mounting Pack. Horizontal Mounting Bar x 2 Plasma Mounting Hardware Pack Phillips Head Mounting Screws (The following thread sizes are included: M4, M5, M6, M8. ) Black Washer x 8 Spacers x 8 (Large & Small) Flanged Nut x 4 Step 6a Install Horizontal Mounting Bars. Find the mounting screws that were supplied with your flat-screen TV. If such screws are not available, find the short Phillips head mounting screws provided in the Plasma Mounting Blister Pack that thread cleanly into the mounting holes in the back of your TV. Attach upper and lower horizontal mounting bar to your TV, as shown, using washers and Phillips driver. Note: If back of TV has a curved surface or if bars do not rest flat, use spacers and long mounting screws provided. Make sure bars are centered, left to right. Fully tighten bars to TV! Horizontal Mounting Bar Flat Screen TV (Back view) Short Mounting Screw Washer Step 6b Install TV with attached horizontal mounting bars to flat panel mounting brackets at desired height by inserting the threaded studs into key holes. Note: Flanged nuts are provided in the Plasma Mounting Blister Pack and must be threaded on the studs of the upper mounting bar in order to prevent any damage to the TV. 1 2 Step 6c Once the threaded posts are positioned through the key holes and slots, lower TV into resting position. Tighten flanged nuts on upper mounting bar. 3 1 2 3 Install the second set of flanged nuts to the threaded posts of the lower mounting bar. Once positioned, fully tighten all flanged nuts! Assembly complete! Fine tuning your new BDI Alcove Home Theater Furniture These steps are to be followed after you have unpacked and completed the simple assembly instructions for your Alcove stand. Due to jostling in freight or perhaps an uneven floor, the doors on your Alcove stand may not appear to be in perfect alignment (Refer to sample cabinet doors shown below). Making a few minor adjustments can rectify this situation. Be aware that depending on your situation, patience and a bit of trial and error are required. The high-quality European hinge hardware is infinitely adjustable, but changing one element can cause the need for further adjustments. [. . . ] · By adjusting Screw 1, the door will move left and right within the frame. For best results, make minor adjustments to top and bottom hinge for best results. · If adjusting Screw 1 has not achieved the desired result, you can adjust Screw 2 and the door will move up and down within the frame (the top and bottom hinges need to be adjusted the same amount). [. . . ]