User manual BECKER 7800 PRO INSTALLATION GUIDE

[. . . ] Symbols used in the Installation Guide . 32 Safety and Installation Instructions . 32 Connection schematic for the OnlinePro . 33 Installation of the GPS/GSM antenna . [. . . ] Check whether the ends of the flex cable still engage in the speedometer and the gearbox. Shorten the inner cable to a projection of 13 mm (Figure 5). Connect the union nut and hose sleeve (Figure 6) and push onto the hose ends (Figure 7). Connect friction washer to dog (Figure 8). Figure 5 · · Figure 6 · Figure 7 Figure 8 46 Subject to errors or technical changes Copyright by Becker GmbH, D-76303 Karlsbad Installation Guide · Remove grease from flex cable and connect dog to flex cable. Using a suitable installation tool, press the dog onto the flex cable (Figure 9). ) · When pressing in, ensure that the dog is securely positioned and that it runs smoothly. Figure 9 Pull the hose sleeve and nut as far as possible in the direction of the dog, to achieve approx. Slightly squeeze the hose sleeve with pliers. Wrap with isolating tape to secure (Figure 11). Screw the connecting piece and the speed sensor into the cable (Figure 12). Electrically connect the speed sensor using the extension cable from VDO (part number: 2152. 90 30 0100). Figure 10 · Figure 11 Figure 12 · Wire connections for the speed sensor Brown - earth (terminal 31) Black - power supply (terminal 15), 9 - 16V, 30 mA Blue/red - signal for socket A pin 1 Subject to errors and technical changes 47 Copyright by Becker GmbH, D-76303 Karlsbad Installation Guide 10. Installation/ Removal of the OnlinePro · Installation: With this radio, a universal mounting for DIN installation slots is integrated. The unit is inserted into the installation slot and secured with the slides supplied. To install, complete all electrical connections. Then push the unit into the installation slot. Subsequently, insert slides into the openings on the front of the unit until the first detent position (Fig. Now lock the radio in by pulling on both slides as shown in Fig. Subsequently, remove the slides. A B ) · The installation angle of the unit must not exceed 0° - 35° (vertical). C Removal: To remove the unit, it must first be unlocked. For this purpose, push in both slides to the second detent position, as shown in Figure A. Subsequently, withdraw the unit with both slides. Then remove the slides by pressing the springs on the right and left sides of the unit. If the unit was installed previously in another vehicle, it may be necessary to adjust the springs on the unit before installation. To adjust the springs, insert slide as shown in Fig. D and subsequently adjust as shown in Fig. [. . . ] Connection socket A is not the same for all vehicle types. Therefore, always measure voltages before installation. Subject to errors and technical changes 57 Copyright by Becker GmbH, D-76303 Karlsbad Installation Guide 15. Troubleshooting Troubleshooting for GPS antennas and faulty installation Fault: Permanent or temporary interference with GPS reception, faulty determination of current position, unit cannot be calibrated. The navigation system calculates the current position from the data received by the integrated GPS satellite receiver. [. . . ]