User manual BECKER CASCADE

[. . . ] Risk of injury due to loose connection Connect the components so that they cannot come loose in the event of a collision or sudden braking. 3 Installation Guide Installation instructions Damage due to polarity reversal or short-circuit Incorrect cable connections and short-circuits can seriously damage the unit. Disconnect the vehicle battery before installing the unit. In order to avoid short-circuits and malfunctions, install the cables so that they cannot be pinched, kinked, chafed or detached. Before installation, park the vehicle in a safe and level place and remove the ignition key. [. . . ] You can then connect to the adapter lead either a commercially available telephone antenna or an antenna that is already installed in the vehicle. If the connections do not fit, you will need to use appropriate adapters. 8 Installation Guide Installation of the microphone The microphone should be placed in the vehicle to allow optimal recognition of the speaker's voice. Possible positions in the vehicle for the microphone can be seen in the following diagram. The installation position should be as far away from the loudspeakers, and as near to the speaker, as possible. If problems occur, different positions should be tested. In order to pick up as little background noise as possible, the microphone has a narrow pick-up angle and must consequently be directed towards the driver. A: B: C: D: E: F: Optimal installation position Alternative installation position Speaking direction on microphone Adhesive strip for affixing to smooth surfaces Screw for fastening the screw-on plate Screw-on plate for affixing to rough or uneven surfaces. Affixing the hands-free microphone to a flat and smooth surface can be accomplished with the adhesive strip D (Clean adhesion surfaces). 9 Installation Guide If the microphone is to be affixed to a rough or uneven surface, the screw-on plate F should be affixed first with the screw E. (To avoid risk of damage to any cables installed underneath or other vehicle components, please pay attention to screw length. ) Subsequently, affix the microphone to the screw-on plate F with the adhesive strip D. The connection of the hands-free microphones takes place in socket C of the Cascade. In order to avoid short-circuits and malfunctions, install the cables so that they cannot be pinched, kinked, chafed or detached. 10 Installation Guide Connecting a microphone to the Cascade a. Connection without CD changer or without remote kit for an iPodTM For connecting the microphone to a device without CD changer or without a remote kit for an iPodTM, the enclosed blue socket must be connected as described below. Cable connections for the speed sensor Brown - earth (terminal 31) Black - power supply (terminal 15), 9 - 16V, 30 mA Blue/red - signal for socket A pin 1 Installing the speed sensor in the speedometer cable In this case, please contact your dealer or VDO representative. A GAL signal 15 Installation Guide Installation/ Removal of the Cascade · Installation: The Cascade features an integrated universal bracket for DIN installation slots. The Cascade is inserted into the installation slot and secured with the slides supplied. To install, complete all electrical connections. Then push the Cascade into the installation slot. Subsequently, insert slides into the openings on the front of the Cascade as far as the first detent position (Fig. Now lock the radio in by pulling on both slides as shown in Fig. The installation angle of the Cascade must not exceed 0° - 35° (vertical). Only the enclosed bolts may be used for an attachment from the rear. · Removal: To remove the Cascade, it must first be unlocked. To do this, remove the control panel and push in both slides as far as the second detent position as shown in Figure A . [. . . ] · Engage the reverse gear for the reverse signal function test. · %DFNZDUGV 8008 must jump from to Drive round a bend to test the function of the internal sensors. The value behind *<52 must change. 22 Installation Guide GPS information - GPS function test Select *36 , QIR in the Service menu. When functionality and GPS reception are working correctly, the number of satellites received (e. g. [. . . ]