User manual BECKER MONZA MP3 7889

[. . . ] Information regarding general road safety This car radio device is intended and approved for installation and operation in passenger cars, commercial vehicles and buses (vehicle classes M, N and O) whose electric system has a rated voltage of 12V. Installation and maintenance should only be carried out by specialists. Faulty installation or maintenance can result in the malfunctioning of the motor vehicle's electronic systems. The vehicle manufacturer's safety instructions must be observed. [. . . ] Before playing the CD, it should be cleaned with a special, commercially available cleaning cloth, wiping from the centre outwards. Solvents such as benzene, thinners or other commercially available cleaners and anti-static sprays must not be used. Note on condensation of humidity During periods of rain or extreme humidity, humidity may condense on the lenses located inside the unit. This will impair the unit's ability to perform CD playback. Remove the CD from the drive and wait for approximately one hour to allow the condensation to evaporate. Notes on CD-R and CD-RWs You can play CD-Rs/CD-RWs (writeable/rewritable CDs) on this unit, but please comply with legal restrictions. These restrictions may vary from one country to another. Depending upon the recording device used to record the CDR/CD-RW and / or the CD-R/CD-RW itself, it may not be possible to play some CD-Rs/CD-RWs on this unit. CD-Rs/CD-RWs must be manufactured according to the "Red Book" or "Yellow Book" standards (not applicable to MP3-CD's). Correct Incorrect Notes on copy-protected CDs In some cases, problems may arise when attempting to play copy-protected CDs, such as long reading times or a total inability to perform playback. Incorrect Correct 64 CD mode Inserting / ejecting CDs Insertion: Insert the disc into the CD slot with the printed side facing upwards. The CD will be drawn into the unit automatically. In the case of an audio CD, the unit will then begin to play the first track and in the case of an MP3 CD, the first track in the first directory. After the last track of the CD has finished playing, the unit will automatically repeat the CD from the first track. If there is already a CD in the slot, press the button. If CD changer / AUX mode was the last selection made, then the multifunction button must be used to switch to CD mode or the multifunction button used to switch to MP3 mode. Forward / backward track skipping Audio CD tracks or tracks from the current MP3 CD directory can be selected by turning the right-hand rotary control. When you get to the last track, in the case of an audio CD the unit continues to the first track or in the case of an MP3 CD, to the first directory. In a similar manner, it switches from the first track back to the final track. If a track has been playing for more than 10 seconds when the skip button is pressed, the unit will skip back to the beginning of the selected track. Scan search Press right-hand rotary control play. , will appear in the dis- Ejecting the CD: To eject a CD, press the ed. Remove the CD. button, and the CD will be eject- All following CD tracks are played for 12 seconds each. Press the right-hand rotary control again to terminate the scan search. Attention: When the unit is turned off, the CD will not be ejected, but will remain in the CD slot. 65 CD mode Fast forward / reverse Fast forward (audible) is activated by pressing the multifunction button and fast reverse (audible) is activated by pressing the multifunction button. Track repeat "Track repeat" is activated by pressing the multifunction button. The prompt Rpt is displayed inversely. Fast forward / reverse terminates when the multifunction button is released. Note: Fast reverse terminates automatically as soon as the beginning of the current track is reached. Pressing the "Track repeat". multifunction button again deactivates Track display Press the button in CD mode. Random play Pressing the multifunction button activates the random play function. Subsequently, the titles from the current CD will be played in random order. The prompt Rnd is displayed inversely. Pressing the multifunction button will briefly display the number of the current track and the total number of tracks. Pressing the multifunction button again deactivates the "Random play" function. 66 CD mode Display CD text If the CD features CD text information, this can be displayed. [. . . ] Subsequently, withdraw the unit using both slides (Figure C). Then remove the slides by pressing the springs on the right and left sides of the unit. If the unit was previously installed in another vehicle, it may be necessary to adjust the springs on the unit before installation. To adjust the springs, insert slide as shown in Figure D and afterwards adjust as shown in Figure E (gently press slide in the direction of "1", whilst at the same time moving the slide in the direction of "2" or "3"). C 2 E D 3 1 80 General instructions General instructions RDS SYSTEM This car radio is capable of receiving RDS signals (RDS = Radio Data System) on the VHF bands. [. . . ]