User manual BEGLEC BEAT 4 MK2 V 1.1

[. . . ] Be sure to use screws of the appropriate size. (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. [. . . ] CROSSFADER ASSIGN: Selects the input channels to be used with the crossfader (11) and beat counters (9). BEAT COUNTER DISPLAY: Shows the number of beat per minute (BPM) of the music on the channel selected with the crossfader assign selector (8). To have a reliable result on the display the music must have a clear and steady beat. BEAT OFFSET INDICATOR: This indicator has several colored LEDs which indicate if the beat on both beat counters are well synchronized. When both beat counters are completely out of sync, the red LEDs will be lit. You will have to adapt the speed of the connected audio sources so the beats will be nicely synchronized. When the synchronization becomes better the yellow LEDs will turn on. Finally, when both beats are in perfect sync, the green led in the center turns on. Now you can mix the beat of 2 audio sources together. CROSSFADER: With this fader you can mix over between the channels you selected with the crossfader assign selectors (8). The crossfader only works when you move the selected channel faders (7) to the desired level! the crossfader also integrates the optical fader starts. See the next chapter for more information on this issue. FADER START ON/OFF SWITCH: When you have a compatible CD-player connected to the fader control connectors, you can control its start/stop (re-cue) functions with the cross fader. With this switch you can turn the fader start control on and off. Make sure the levels do not exceed 0dB (or 100%). The audio risks to be distorted when the signal level comes in the red zone of the VU-meter. PFL VU METERS: Monitors the level of the channel you selected with the PFL-switch (6). Make sure the levels do not exceed 0dB (or 100%). CUE MIX: With this fader you can mix the master output and any of the input channels through the headphone output (17): · Put the fader in the extreme left position to monitor a selected PFL signal (6). Put the fader in the extreme right position to hear the master output. Put the fader in any other position to hear a mix of the two signals. [. . . ] INPUT CHANNELS: each used to connect two different line level audio signals. refer to switch (31) to change one line input to phono level. The input source selector (2) on the front determines which input will be active. LINE INPUT CHANNEL1: used to connect a line level audio signal to channel1. [. . . ]