User manual BEGLEC BEAT 6 USB V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] Except for microphones, headphone and master outputs, all connections are cinch. use good quality cinchcinch cables to prevent bad audio quality. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. In this manual we talk about "line inputs". This is a global name for inputs with a level up to 2V. this includes tuners , videos , CD-players , etc. Both USB connections will be detected as a sound card on your computer. These connections are bidirectional (play/record music simultaneously) Accepts either a balanced microphone with an XLR connector or an unbalanced microphone with 1/4" mono jack. This input is mainly used as DJ-microphone. The talk over does not affect the signal level of this input. Use this control to adjust the level of the DJ microphone on the VU-meter at about 0dB. PANPOT CONTROL: Used to locate the sound from the DJ mic somewhere in the stereo field. A panpot control does the same for mono signals as a balance control does for stereo signals. TALKOVER: Use the switch to automatically mute the input channels 1 to 5 while you are talking through the DJ microphone. you can adjust the amount of muting on input channels 1 to 5. The more you turn the talkover level to the right, the more these channels are muted while talking through the DJ Mic(1). Pressing multiple Cue-buttons makes it possible to derive a mixed sound from the selected sources. CHANNEL FADER: Used to set the level of each channel separately. You can easily exchange this fader with a new one. Later in this manual we explain how to do this. CHANNEL VU METER: Each channel has its own LED VU-meter so you can adjust the gain level (11) very quickly. [. . . ] CROSSFADER MOVES TO THE RIGHT: CD-player connected to fader start connector A stops playing, returns to its previously programmed cue point and waits in pause. The other CD-player starts playing from its previouslyprogrammed cue point. CROSSFADER IN RIGHT POSITION: CD-player connected to fader start connector B is playing, the other CD-player is paused. CROSSFADER MOVES TO THE LEFT: CD-player connected to fader start connector B stops playing, returns to its previously programmed cue point and waits in pause. [. . . ]