User manual BEGLEC BPM 4 USB V 1.0

[. . . ] `t Hofveld 2C ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. This symbol means: indoor use only Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Except for microphones, headphone and master outputs, all connections are cinch. use good quality cinchcinch cables to prevent bad audio quality. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. In this manual we talk about "line inputs". This is a global name for inputs with a level up to 2V. this includes tuners , videos , CD-players , etc. Both USB connections will be detected as a sound card on your computer. These connections are bidirectional (play/record music simultaneously) GAIN LEVEL: Adjusts the input level on each channel. Use this control to adjust the level on the VUmeter at about 0dB. 3-BAND TONE CONTROLS: The frequency of each channel can be controlled separately over a range from -26dB to +12dB. BEAT COUNTER DISPLAY: Shows the number of beat per minute (BPM) of the music on the channel selected with the crossfader assign selector (12). To have a reliable result on the display the music must have a clear and steady beat. FADER START ON/OFF SWITCH: When you have a compatible CD-player connected to the fader control connectors, you can control its start/stop (re-cue) functions with the cross fader. With this switch you can turn the fader start control on and off. CROSSFADER: With this VCA fader you can mix over between the channels you selected with the crossfader assign selectors (12). The crossfader only works when you move the selected channel faders (4) to the desired level! the crossfader also integrates the optical fader starts. See the next chapter for more information on this issue. [. . . ] The input source selector (6) on the front determines which input will be active. PHONO/CD SWITCH: This switch makes it possible to switch between the CD and phono level inputs on channels 2, 3 and 4. It is preferable to connect this signal ground to the GND-connector. If your turntable does not have a ground wire, you don't have to use this connector. [. . . ]