User manual BEGLEC BT-575S V1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this BriteQ product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] The installations should be inspected every year by a skilled person to be sure that safety is still optimal. ATTENTION: Install the gobos only when the unit is switched off! never unscrew the screws of the rotating gobo as the ball bearing will be opened. switch off the main supply and unplug the unit. Open the plastic top cover (4screws) Locate the gobo wheel and remove the fixation ring of the gobo you want to change with an appropriate tool. remove the gobo and insert the new gobo. Press the fixation-ring together and insert it in the front of the gobo. BUTTONS MENU DOWN UP ENTER To To To To select the programming functions go backward in the selected functions go forward in the selected functions confirm the selected functions On On On Flashing DMX input present Master mode Slave mode Sound activation Show Mode Used to choose the Show mode when used in standalone or master/slave mode. Once the right mode shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in standalone or master/slave mode. SENSITIVITY: Used to adjust the sensitivity of the micro when the unit is used in standalone or master/slave mode. MAIN MENU: To select any of the pre-set functions, press the MENU button up to when the required one is shown on the display. After 8 seconds the display will automatically return to the main functions without any change. To go back to the functions without any change press the MENU button. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Once the mode is selected, press the ENTER button to setup ( or automatically return to the main functions without any change after 8 seconds. ) To go back to the functions without any change press the MENU button again. Show 3 mode - Fixture is placed on a podium, in front of the audience The spot is always projecting to the audience's direction; i. Tilt movement angle: 90° ( 60° above horizon; 30° below horizon. ) Show 4 mode - Fixture is fixed under ceiling. [. . . ] mASTER has 4 built-in shows: You can select (show 1) , (show 2) , (show 3) or (show 4) directly in the menu of the master. SLAVES have 2 working options: The other units are set to slave mode (slaveLED is constantly on). In order to create a great light show you can introduce contrast movements (pan/tilt of slave is inversed) In the menu of the slave units you can go to option and select: o Normal slave: slave works in sync with the master. O 2 light show: slave works in opposite with the master. [. . . ]