User manual BEGLEC BT-575W V1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this BriteQ® product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in standalone or master/slave mode. SENSITIVITY: Used to adjust the sensitivity of the micro when the unit is used in standalone or master/slave mode. MAIN MENU: To select any of the pre-set functions, press the MENU button up to when the required one is shown on the display. After 8 seconds the display will automatically return to the main functions without any change. To go back to the functions without any change press the MENU button. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Once the mode is selected, press the ENTER button to setup ( or automatically return to the main functions without any change after 8 seconds. ) To go back to the functions without any change press the MENU button again. Show 3 mode - Fixture is placed on a podium, in front of the audience The spot is always projecting to the audience's direction; i. Tilt movement angle: 90° ( 60° above horizon; 30° below horizon. ) Show 4 mode - Fixture is fixed under ceiling. The spot is mainly projecting in front of the stage. Pan movement angle ( left to right to left ) :160°. [. . . ] Every time you turn the unit on, it will show 575U on the display and move all the motors to their `home' position and you may hear some noises for about 20 seconds. After that the unit will be ready to receive DMX signal or run the built-in programs. YOU CAN OPERATE THE UNIT IN FOUR WAYS: o By master/slave built-in preprogram function o By CA-8 easy controller o By universal DMX controller ( 8 & 16 channel DMX mode ) o By iLead controller ( The BT-575W must be switched to 8 channel DMX mode ) BY MASTER/SLAVE BUILT-IN PREPROGRAM FUNCTION: Select this function when you want an instant show. By linking the units in master/slave connection, the first unit will control the other units to give an automatic, sound activated, synchronized light show. [. . . ]