User manual BEGLEC CMX-24 V1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] The table below gives you all the information to set your fade time (x is a digit between 0 and 9) Display Time 0. Master A changes to 100% and Master B changes to 0%. You will a slow fade from the first scene to the second scene. Channel 1 at 100% Channel 2 at 50% (A:50% is higher then B:25%) Channel 3 at 75% (B:75% is higher then A:25%) This only works when BOTH masters are set at 100%. Master B will be set at 100% ( this is visible on the green leds). When a fade time is set, this will happen slowly. press and hold the <1-24> button above the Master A fader. Master A will be set at 100% ( this is visible on the green leds). When a fade time is set, this will happen slowly. CHASE/SCENES mode This control mode allows you to store a scène or a chase of 24 channels in every Preset B fader. the CMX24 has 4 pages , so you can store altogether 48 scenes/chases. You can activate this mode like this: Press and release the <MODUS SELECT/REC SPEED> button until the [CHASE SCENES] lamp is lit above the master A/B faders. The light effects keep the actual intensity. The light effects will adapt directly to the new intensities. Using the HOLD button you can maintain the current scene while setting the next scene. Move the {FADE} fader until the display shows [10. The scène will change slowly (within 10 seconds) from the previous to the next. DOUBLE PRESET MODE: In this mode you can use the control as an 12 channel A-B control. Change the mode to double preset: Press and release <MODUS SELECT/REC SPEED> until the [DOUBLE PRESET] lamp will be lit above the master A and master B faders. Only this setting will be showed constantly. a chase contains multiple scenes and each scene contains the intensity for 24 channels. The scenes will be showed one by one (and you can set the speed/fade time). [. . . ] That's why it is better to place the de Preset B fader in the lowest position, before to activate the normal mode SINGLE CHASE De single chase mode is useful to create quickly different chases. When Single chase (indicate with the PARK button) is activated, the CMX24 will create chase, based on all the preset B faders that are not set to zero. Each preset B fader will be activated till all the fader positions are shown. Then, the next preset B fader will be shown. [. . . ]