User manual BEGLEC CONTROL 5.2 V 1.2

[. . . ] ⷠTo avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. ⷠThis unit is for indoor use only. ⷠDon't place metal objects or spill liquid inside the unit. [. . . ] ⷠTo avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE MIXER: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. Except for microphones, headphone and zone outputs, all connections are cinch. use good quality cinch-cinch cables to prevent bad audio quality. (example: JB Systems code: 2-0370) For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. In this manual we talk about "line inputs". This is a global name for inputs with a level between 750mV and 2V. DJ MICRO input: The DJ micro can be connected to the XLR/Jack input on the front plate or to the stereo jack on rear panel. This input is balanced but accepts any kind of microphone equipped with an XLR or jack connector. TALKOVER level: When you switch the talkover(3) on, you can adjust the amount of muting on input channels 2 to 5. The more you turn to the right, the more these channels are muted while talking through the DJ Micro(1). TALKOVER switch: Use this switch to automatically mute the input channels 2 to 5 while you are talking through the DJ microphone. Use the zone selectors(4) to choose on which output the talkover should work. Attention: the talkover will only work on the zone you selected for the DJ Micro. ZONE switch: for every input channel you can choose to which zone (master) it should be routed. This means that you can use this mixer to serve two different rooms with completely different music!But you want to be able to make announcements in both rooms. This is what you should do: · Now you can do announcements in both rooms, while the music you play in both rooms is completely different. INPUT SELECTOR switch: On channels 2 and 3 you can choose between line or balanced micro inputs. [. . . ] The output level can be set by the MASTER A level (18). RECORD BUS B: line level output with the signals from channels 2 to 5. Only the channels where you selected zone B will be on this output. Important note: the tone controls, DJ microphone and talkover function are NOT available on this output. [. . . ]