User manual BEGLEC DMX512

[. . . ] TABLE OF CONTENTS 1. Safety Instruction 2. Technical Specification 3. Lamp 4. How To Set The Unit 4. 1 Control Panel 4. 2 Main Function 4. 3 Home Position Adjust 5. How To Control The Unit 5. 1 Master/Slave Built-In Preprogrammed Function 5. 2 Easy Controller 5. 3 iSolution Operation / DMX Controller 5. 4 DMX512 Configuration 5. 5 DMX512 Connection 6. Troubleshooting 7. Fixture Cleaning User Guide WWW. BEGLEC. COM 1- 1. Safety Instruction Please read carefully the instruction, which includes important information about the installation, usage and maintenance. WARNING Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. [. . . ] Use DOWN and UP button to select the (pan inversion) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. Tilt Inversion Press the MENU button up to when the or is shown on the display. Pressing ENTER (normal) button, the unit will focus on tilt 135°, and then the unit will first focus on tilt 45°, pan 0°, pan 90°, pan 180°, pan 270° each time your press ENTER button. Use DOWN and UP button to adjust fixable gobo wheel focus. To go back to the functions press the MENU button again. Gobo2 focus Adjust Press the MENU button up to when the is blinking on the display. Pressing ENTER button and the display will blink. Use DOWN and UP button to select the (tilt inversion) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. Pressing ENTER button and the display will blink. Use DOWN and UP button to adjust the tilt home position. Once the position has button and the display will show the number of working hours of the unit. To go back to the button and the display will blink. Use DOWN and UP button to select the (Lamp off) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. Reset Press the MENU button up to when the functions press the MENU button again. DMX RESET : Set DMX value of channel 8 and channel 16 to 255, then all channels of the unit will return to their standard home position. Pressing ENTER been selected, press the ENTER button to setup or automatically return to the offset functions without any change press the MENU button again, To go back to the main functions without any change after 8 seconds. Focus Adjust Press the MENU button for at least 5 seconds into offset mode, use DOWN and UP button up to when the is shown on the display. [. . . ] Some units don't respond to the easy controller 1. You may have a break in the DMX cabling. Check the LED for the response of the master/ slave mode signal. Set the proper address. C D C D A B E H B A F D. [. . . ]