User manual BEGLEC DMX512 MOVING HEAD SPOT

[. . . ] Professional Lighting Technology WWW. BEGLEC. COM User Guide Please read these instructions carefully before use Note TABLE OF CONTENTS 1. Technical Specification 2. 1 Inserting/Exchanging rotating gobos 3. How To Set The Unit 4. 1 Control Panel 4. 2 Main Function 2A 5. [. . . ] Check the main voltage either too high or too low. Check and if necessary replace the fan on the head. Dimension: 360mm x 397mm x 503mm (L x W x H) Weight: 26 kg 5. 5. DMX512 Connection The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. Luminous intensity: 2. 1. Inserting/Exchanging rotating gobos DANGER! Install the gobos with the device switched off only. Unplug from mains before changing gobos! 6A Open the cover by loosening the fastening screw at the sides of the cover. If you wish to use other forms and patterns as the standard-gobos, or if the gobos are to be exchanged, remove the fixation ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the fixation-ring together and insert it in the front of the gobo. 1. If you use a controller with 5 pins DMX connector, you need to use a 5 to 3 pin adapter. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last unit. Connect the unit together in a "daisy chain" by XLR plug from the output of the unit to the input of the next unit. The cable cannot be branched or split to a "Y" cable. Inadequate or damaged cables, soldered joints or corroded connectors can easily distort the signal and shut down the system. The DMX output and input connectors are pass-through to maintain the DMX circuit, when power is disconnected to the unit. Each lighting unit needs to have an address set to receive the data sent by the controller. The address number is between 0-511 (usually 0 & 1 are equal to 1). 6. The end of the DMX512 system should be terminated to reduce signal errors. 3 pin XLR connectors are more popular than 5 pins XLR. CAUTION! Never unscrew the screws of the rotating gobo as the ball bearing will otherwise be opened! 3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+) 5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+) 3. Lamp In case of replacement of the lamp or maintenance, do not open the fixture within 15 minutes until the unit cools down after switching off. Because of its high internal pressure, there might be a risk that the Discharge lamp would explode during operation. The lamp emits intense UV radiation which is harmful to the eyes and skin. [. . . ] Use DOWN and UP button to select the Press the MENU button up to when the is blinking on the display. Pressing ENTER button, the unit will focus on tilt 90°, and then the unit will focus on pan 0°, pan 90°, pan180°, pan270° in every pressing ENTER button. To go back to the functions press the MENU button again. (split color) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. [. . . ]