User manual BEGLEC F-80Z

[. . . ] Refer to your Antari dealer or other qualified service personnel. Fog machine must be installed out of the reach of children. Never leave the unit running unattended. Leave the grid guarding the nozzle in place if the machine is to be used in the presence of children. [. . . ] Always drain tank before shipping or otherwise transporting this unit. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Unpacking & Inspection Open the shipping carton and check that all equipment necessary to operate the system has arrived intact. In addition to the F-80Z, you should receive the following items: 1. Before beginning initial setup of your Antari Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your Antari dealer for assistance. Fill with Antari Fog Liquid or other high-quality water-based fog fluid. Any other types of fluid can damage the unit. When filled, place cap back on liquid tank. Maintenance Operation 3 Plug power cord into a grounded electrical outlet. If necessary, turn power switch on rear of unit to "ON" position. Warm-up is complete when green lamp lights up on remote unit. to emit fog , press the button on the remote and hold for the desired length of time. The remote unit's lamp will cycle on and off as the machine re-heats to the proper operating temperature. For further information on operating your Antari Fog Machine, see the section titled, "Remote Control Operation". installation The F-80Z fog machine includes a mounting bracket designed for overhead installation. This bracket allows the unit to be hung from lighting equipment trussing or other suitable supports. The unit can also be operated at floor level or sitting on any regular surface as well. If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at any one's face. Therefore, do not point the nozzle in a direction that will aim directly at a person. Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of inclination. Remote Control Operation FCW-80: 3 meter wire remote controller with three-prong plug for Antari Fog Machine model F-80. [. . . ] Check fluid level, the external fuse, remote connection, and power from the wall. If fog does not come out after holding the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit. Return the machine to your Antari dealer. [. . . ]