User manual BEGLEC FALCON VERSION 1.0

[. . . ] Don't place metal objects or spill liquid inside the unit. electric shock or malfunction may result. If a foreign object enters the unit, immediately disconnect the mains power. Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. [. . . ] this will drastically shorten the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Put the installed lamp back inside the unit as shown on the photo. Be sure that the wires don't touch the lamp reflector. Close the lamp compartment with the 2 screws. With switch n°10 you can inverse the movements. The red led is on when the unit is switched on. This input receives instructions from a DMX-controller or from another Falcon light effect when used in master/slave mode. DMX OUTPUT: 3pin female XLR-connector used to connect the Falcon with the next unit in the DMX chain or with another Falcon when used in master/slave mode. Use the small knob on top of the Falcon to adjust the focus of the gobos: · Loosen the knob (see photo) a little until you can move it forward and backward. Standalone 1unit: Just connect the unit to the mains and put on some music. The unit will start working automatically to the rhythm of the music. Two or more units in master/slave setup: Connect 2 or more units together using good quality balanced XLR microphone cables (like for example JB Systems code 7-0063). The unit that has no cable connected to its input will react as master; the others are the slave units. You don't have to worry about the settings of the DMX DIP-switches!It is only possible to inverse the behavior of a slave unit by changing the position of DIP-switch n°10. Connect the optional CA-8 controller for more control: The CA-8 controller can only be used in standalone or master/slave mode. Blackout, the lamp will be switched off automatically to extend its lifetime. The beam movements and gobo/color wheel are both sound activated. press the button to switch the led on; now the Falcon is in SLOW mode. The beam movements are sound activated but the gobo/color wheel is static and can be controlled with the FUNCTION-button. FUNCTION BUTTON: (strobe/next) Push the FUNCTION button while the Falcon is in FAST mode (MODE led is off) the units will strobe in 3 different ways: · Two-light strobe in white color Every time you push the FUNCTION-button while the Falcon is in SLOW mode (MODE led is on) the colors/gobos of the connected units change. [. . . ] We declare that our products (lighting equipment) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. We declare that our products (Remote Controller) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. We declare that our products (lighting equipment) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. We declare that our products (Remote Controller) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. [. . . ]