User manual BEGLEC HIGH Q30 D MK2 V 1.1

[. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Thank you for buying this JB Systems product. [. . . ] This makes it easier to manipulate the record for scratch performances. TARGET LIGHT: Target light used to locate the exact place on your record when used in a dark place. REVERSE BUTTON: Press this button to reverse the platter rotation, press this button again to end the reverse mode. (normally used for beat mixing) · Press again for +/-20% speed range. QUARTZ LOCK BUTTON: When the QUARTZ Button is pressed, the exact center speed (0%) is enforced, even when the pitch slider is not in the middle. When the slider is in its middle position, the led next to the pitch slider will turn green to indicate that the turntable is locked to the exact center speed. When the slider is not in the middle the led turns red. Attention: take care that the Quartz lock button is switched off. SINGLE ADAPTER: Place this adapter on the platter for playing 7" records with large center holes. POWER CORD CONNECTOR: Used to connect to the mains, using the supplied power cord. PHONO/LINE SWITCH: Depending on the position of the phono/line switch, you can connect the turntable to any phono or line level input. PHONO/LINE OUTPUT: Connect the turntable to any phono or line level input. Be sure to put the phono/line switch in the correct position. To start playback, gently place the stylus on the record using the head shell finger support. Do not drop the stylus onto the record as this may cause damage to the diamond tip and to the record. For the correct stylus pressure, please refer to the user manual of your cartridge. Setting up the stylus pressure: Make sure the cartridge is well fitted and its needle protector is removed. Put a record on the platter and make sure the antiskate is set to zero. [. . . ] This prevents the tone arm from accidentally turning towards the platter and damaging the needle of the cartridge. HEAD SHELL LOCKING NUT: Attach the head shell by inserting it into the front end of the tone arm and then turn the locking nut clockwise. During installation, attach the stylus protector to guard the stylus tip from damage. [. . . ]