User manual BEGLEC ICOLOR 4 MK2 V1.2

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] ) When replacing parts, please only genuine spare parts. Switch off the unit and unplug the mains cable. Wait for about 10 minutes until the unit has been cooled down. Use a screwdriver to unscrew the screw that closes the lamp compartment of the fixture. Hold the lamp firmly while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. Don't touch the bulb with bare hands! this drastically shortens the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Close the lamp compartment with the screw. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. This input receives instructions from a DMX-controller or from another iCOLOR4 Mk2 light effect when used in master/slave mode. DMX output: 3pin female XLR-connector used to connect the iCOLOR4 Mk2 with the next unit in the DMX chain or with another iCOLOR4 Mk2 when used in master/slave mode. Button used to control the music sensitivity 6. DIP switches, used to set the DMX-starting address and DMX-mode of the unit. In stand alone this red led blinks to the rhythm of the music, in DMX mode this led flashes when a DMX signal is detected. Lamp compartment, to be opened with this screw. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience! [. . . ] The CA-32 Colormix can even be further extended with the CA-32F foot controller for maximum control on stage!Most functions of the CA-32 can be controlled by the 4 foot switches. Controlled by universal DMX-controller: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected light effects with a good quality XLR M/F balanced cable (ex. [. . . ]