User manual BEGLEC IM-8S

[. . . ] Technical Specifications IM-8S Power Fuse Lamp AC 120V~60Hz or AC 230/240/250V 50/60Hz 20mm Glass 10A Fast Blow MSD 250/2 Dimension 360mm x 397mm x 503mm Weight 26 kg IM-7S Power Fuse Lamp AC 120V~60Hz or AC 230/240/250V 50/60Hz 20mm Glass 7A Fast Blow HTI 150W Dimension 373mm x 295mm x 451 mm Weight 13 kg IM-8S IM-7S Innovation , Quality , Performance User Guide WWW. BEGLEC. COM 7. Fixture Cleaning The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit's optics. Clean with soft cloth using normal glass cleaning fluid. [. . . ] If you wish to use other forms and patterns as the standard-gobos, or if the gobos are to be exchanged, remove the fixation ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the fixation-ring together and insert it in the front of the gobo. CAUTION!Never unscrew the screws of the rotating gobo as the ball bearing will otherwise be opened! 2. 2 Beam angel 3. Lamp In case of replacement of the lamp or maintenance, do not open the fixture within 15 minutes until the unit cools down after switching off. Because of its high internal pressure, there might be a risk that the Discharge lamp would explode during operation. The lamp emits intense UV radiation which is harmful to the eyes and skin. The high luminance of the arc can cause severe damage to the retina if looks directly at the lamp. Discharge lamp : MSD 250/2 (IM-8S) HTI 150W (IM-7S) 1. Always switch off the main supply and never handle the lamp or luminaries when is hot. If this happens, clean the lamp with denatured alcohol and wipe it with a lint free cloth before installation. Never operate the lamp without appropriate shielding. When burning, the lamp operates at high pressure and there is a slight risk of arc tube rupture. The risk increases with age, temperature and improper handling of the lamp. Do not use the lamp any longer than its specified life. Make sure the lamp is located in the center of the reflector for the best spot. Adjust lamp position by screws A, B and C. 7D 5. 5 DMX512 Connection The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. 1. If you use a controller with 5 pins DMX connector, you need to use a 5 to 3 pin adapter. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last unit. Connect the unit together in a "daisy chain" by XLR plug from the output of the unit to the input of the next unit. [. . . ] Fixture Hours Press the MENU button up to when the is blinking on the display. Pressing ENTER button and the display will show the number of working hours of the unit. To go back to the functions press the MENU button again. Reset Press the MENU button up to when the is blinking on the display. [. . . ]