User manual BEGLEC IMOVE 250W MOVING WASH

[. . . ] TABLE OF CONTENTS iMove 250W Moving Wash 1. Safety Instruction 2. Technical Specification 3. Lamp 4. How To Set The Unit 4. 1 Control Panel 4. 2 Main Function 4. 3 Home Position Adjustment 5. How To Control The Unit 5. 1 Master/Slave Built-In Preprogrammed Function. 5. 2 Easy Controller 5. 3 iSolution Operation / DMX Controller 5. 4 DMX512 Configuration 5. 5 DMX512 Connection 6. Troubleshooting 7. Fixture Cleaning User Guide BEGLEC cva ­ `t Hofveld2 ­ 1702 Groot Bijgaarden Belgium WWW. BEGLEC. COM 1- 1. Safety Instruction Please read carefully the instruction, which includes important information about the installation, usage and maintenance. WARNING Please keep this User Guide for future consultation. [. . . ] Pan movement angle ( left to right to left ): 160°. below horizon. ) Show 4 mode - Fixture is fixed under ceiling. The spot is mainly projecting in front of the stage. Pan movement angle ( left to right to left ) :160°. Tilt movement angle: 90° ( vertically, front 75°; back 15° ) Slave Mode Press the MENU button up to when the is shown on the display. Pressing ENTER (normal) Tilt movement angle: 90° ( 60° above horizon; 30° Press the MENU button up to when the or is shown on the display. Pressing ENTER (normal) button and the display will blink. Use DOWN and UP button to select the (tilt inversion) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. Led Display Press the MENU button up to when the (Led on) or is showing on the display. Pressing ENTER button and the display will blink. Use DOWN and UP button to select the (Led off) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. Display Inversion It is good for you to install the unit on the floor or under ceiling. Press the MENU button up to when the is blinking on the display. Use the ENTER button to change to the mode 11- button and the display will blink. Use DOWN and UP button to select the (2 light show) mode. Once the mode has been selected, press the ENTER or button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. 10- (display inversion), It will automatically store after 8 seconds. [. . . ] Troubleshooting Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting: A. The unit does not work, no light and the fan does not work 1. Measure the mains voltage on the main connector. [. . . ]