User manual BEGLEC IMOVE 8W MOVING WASH

[. . . ] iMove 8W Moving Wash Innovation , Quality , Performance WWW. BEGLEC. COM 7. Fixture Cleaning The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit's optics. Y Clean with soft cloth using normal glass cleaning fluid. [. . . ] 3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+) 5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+) 6A 3. Lamp In case of replacement of the lamp or maintenance, do not open the fixture within 15 minutes until the unit cools down after switching off. Because of its high internal pressure, there might be a risk that the Discharge lamp would explode during operation. The lamp emits intense UV radiation which is harmful to the eyes and skin. The high luminance of the arc can cause severe damage to the retina if looks directly at the lamp. Always switch off the main supply and never handle the lamp or luminaries when is hot. If this happens, clean the lamp with denatured alcohol and wipe it with a lint free cloth before installation. Never operate the lamp without appropriate shielding. When burning, the lamp operates at high pressure and there is a slight risk of arc tube rupture. The risk increases with age, temperature and improper handling of the lamp. Do not use the lamp any longer than its specified life. Make sure the lamp is located in the center of the reflector for the best spot. Adjust lamp position by screws A, B and C. 7A i. ) Channel 14 ­Pre-programmed show pattern: 1. ) DMX value 0-31, the fixture is still controlled by DMX control . 2. ) For DMX Value above 31, all the DMX control will be invalid . The fixture will run the pre-programmed show patterns(Pan/Tilt movement). ii. ) Channel 15-Pre-programmed beam pattern: One can select the beam pattern only when the pre-programmed show pattern is activated. iii. ) For DMX Reset, put DMX value of CH-8 & CH-16 to 255. 5. 4. Control Panel Display To show the various menus and the selected functions . LED 8A DMX MASTER SLAVE SOUND Button MENU DOWN UP ENTER Remote controller input On On On Flashing DMX input present Master mode Slave mode Sound activation To select the programming functions To go backward in the selected functions To go forward in the selected functions To confirm the selected functions By connect to the 1/4" microphone jack to control the unit for Stand by, Function, and Mode function. Sensitivity To adjust the sound-receiving sensitivity . Microphone To receive audio signal for sound activation . DMX input/output For DMX512 link, use 3-pin XLR plug cable to link the unit together. 4. 2. [. . . ] Pressing ENTER button, the unit will focus on tilt 90°, and then the unit will first focus on pan 0°, pan 90°, pan 180°, pan 270° each time your press ENTER button. To go back to the functions press the MENU button again. Self-Test Press the MENU button up to when the is blinking on the display. Pressing ENTER button and the unit will run self-test by built-in program. [. . . ]