User manual BEGLEC LASER BURST II VERSION 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] All protective measures for a safe operation of this laser must be applied. COOLING FAN: used to cool the components inside the enclosure. Make sure to never cover this fan outlet!INTERLOCK input: used to connect the optional emergency stop switch (see picture). When you push this switch the laser beam will disappear immediately. For your own safety we strongly recommend to connect this optional switch!This product is a so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700 nm and producing lighting effects for shows. Due to the construction of this laser, the beam is moved so fast, that it can only hit the eye very short. This is why the use of this laser for a Laser-Light-Show can be regarded as save. Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!ON/OFF KEY ACTUATED SWITCH: used to switch the unit on/off. Use the keys to make sure only a skilled operator is able to switch the laser on. INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. This input receives instructions from a DMX-controller. DMX OUTPUT: 3pin female XLR-connector used to connect the LASER BURST with the next unit in the DMX chain. DISPLAY: shows the selected DMX address when the unit is in DMX-mode. Apart from DMX-mode you can also select 4 other working modes, see further to learn more about these modes. [. . . ] Note: When no music is detected, the laser output will be shut off (blackout). 2) FULL AUTOMATIC MODE: The laser automatically runs a preprogrammed sequence. Select this mode when only 1 laser is used (standalone) or when the laser is placed as the first (master) unit in a chain with several Laserburst II lasers. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. [. . . ]