User manual BEGLEC LD-POWER 60 V1.0

[. . . ] `t Hofveld 2 ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this BRITEQ product from our Light Designer Series. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] Two different splitters are available: o LD-SPLIT RJ45: used for normal indoor applications (ex. lD-BAR) o LD-SPLIT IP68: used for waterproof outdoor applications (ex. LD-AQUA, LD-UPLIGHT) TYPE 2: these LED-projectors always have two female RJ45 connectors (in/out). for example: LDBRICK , LD-DOWNLIGHT , . You can simply daisychain these projectors with standard patch cables. MASTER LED: is lit when no cable is connected to the DMX-input, the unit works in master mode and shows the last selected internal show. SLAVE LED: is lit when the DMX input is connected to another LDPOWER60/120 that works in master mode. POWER LED: is lit when the mains cable is inserted and the unit is working. Press this button for about 2seconds to leave the setup menu and save the selected options. DOWN BUTTON: press this button to go to the previous item in the setup menu or lower the value shown on the display. UP BUTTON: press this button to go to the next item in the setup menu or increase the value shown on the display. ENTER BUTTON: press this button to confirm your selection in the setup menu. Important: The installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. The LD-POWER60/120 should be fixed on a non-flammable flat surface. For example you can fix the unit against a wall using two adapted screws. The orientation is not important but make sure that enough ventilation is available. Make sure the unit is not connected to the mains during installation and wiring!The LD-POWER power supplies are intended only for use with passive LED projectors from our LD-series. Make sure the maximum load per LED output zone is not exceeded! the maximum cable length between the LD-POWER output and all connected projectors is 80meters!At the end of each line (zone) NO RJ45 connector can be left open, you MUST use a terminator (LD-TERM RJ-45) otherwise: NO light !RGB and RGBW projectors can NOT be mixed in the same line (zone). [. . . ] Press the ENTER button to select: all connected projectors turn to white color (all colors at maximum, except for white) while the display shows (LD-POWER60) or (LD-POWER120) Use DOWN and UP buttons browse the different options: For each option you can press ENTER, follow by the UP/DOWN buttons to set the desired level. Each time confirm with the ENTER button. Or (red for zone 1 on LD-POWER120) or (green for zone 1 on LD-POWER120) or (blue for zone 1 on LD-POWER120) (red for zone 2 on LD-POWER120) (green for zone 2 on LD-POWER120) (blue for zone 2 on LD-POWER120) Press the MENU button for about 2 seconds to save the setting and return to running mode, press shortly to return without saving. Remark: You can only set values between 125 and 255. [. . . ]