User manual BEGLEC LED BALL OUTDOOR V1.4

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] In most cases you will have to connect the 3 contacts to a female stereo 6. Check the drawing to see how the contacts must be wired. When all cables are well connected, you must tighten the cable entry glands so the cables are fixed and the unit is waterproof!Remark: You don't have to use connectors when the unit is used in a fixed installation. However we strongly suggest to use XLR & JACK cable connectors when the unit is used in mobile applications. ) Electrical installation for 1 standalone unit: Just install the mains cable (refer to point A) Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. refer to section "D" to learn how to do this. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables (like for example JB Systems MC-01 cable). refer to sections "B" and "C" to learn how to connect the units together. The unit that has no cable connected to its DMX-input will react as "master", the others are the slave units. Make sure that all units are connected to the mains. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. refer to section "D" to learn how to do this. Electrical installation for two or more units in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable (ex. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!Make sure that all units are connected to the mains. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Gently unscrew the plastic dome from the plastic base and separate both parts. [. . . ] In that case you still have to set the DMX-addresses of these DMX-effects manually!Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience! [. . . ]