User manual BEGLEC LED BLINDER V1.0

[. . . ] DANGER ~ GEVAAR ~ GEFAHR ~ PELIGRO ~ PERIGO ! WARNING: DANGER!never expose the lens to direct sunlight, even for a short period. This may damage the light effect or even cause fire!n'exposez jamais la lentille directement aux rayons de soleil, même pendant un bref instant. [. . . ] If you want to go back to normal running mode: press the MENU button for about 2 seconds. 1. COOLING FANS: these fans are temperature controlled so most of the time they will NOT work, this is normal!Make sure the fans are always clean and never cover the holes, this will result in possible overheating. BRACKET: used to hang the projector in truss (optional truss clamp needed). Also used as heavy duty floor stand for use on stage. DISPLAY shows the various menus and the selected functions. LEDS: DMX On DMX input present MASTER On Master mode SLAVE On Slave mode SOUND Flashing Sound activation 5. BUTTONS: MENU To select the programming functions DOWN To go backward in the selected functions UP To go forward in the selected functions ENTER To confirm the selected functions 6. MICROPHONE: used to control the music activated internal programs 7. DMX INPUTS: connect this input to the previous unit in the DMX chain or directly to the DMX-controller. DMX INPUTS: connect this input to the next unit in the DMX chain. REMOTE CONTROL connector: used to connect the CA-8 hand controller 10. SECURITY EYEBOLT: used to secure the unit with an optional safety cable. 11. MAINS POWER IN/OUT: IEC in/outputs, use the supplied IEC-cable to connect the projector to the mains. You can also daisy chain up to 10 units using the optional IEC-extension cables, available under order code 4151 (L=1m), order code 4152 (L=5m). 12. FUSE HOLDER: always exchange a broken fuse with the same 20x5mm 6, 3A type. OVERHEAD RIGGING Important: The installation must be carried out by qualified service personal only. You will be asked which preprogrammed show you want to use: choose from 2-1 to 2-8. (Note that this setting is only relevant while used without any controller, you can change the speed using the menu buttons on the master) You will be asked which playback speed you want for the show: choose from 0 to 255. (Note that this setting is only relevant while used without any controller, you can change the speed using the menu buttons on the master) 5 * 10: select this option when the unit is used in a master/slave setup with several units placed in a 5x10 matrix (5 units mounted on top of each other, using the optional matrix bracket). You will be asked which preprogrammed show you want to use: choose from 3-1 to 3-8. (Note that this setting is only relevant while used without any controller, you can change the speed using the menu buttons on the master) You will be asked which playback speed you want for the show: choose from 0 to 255. (Note that this setting is only relevant while used without any controller, you can change the speed using the menu buttons on the master) To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. [. . . ] In the next section you will learn how to set the DMX addresses. HOW TO SET THE RIGHT START ADDRESS: Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit. The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user manual which starting addresses you have to set because this completely depends on the selected channel mode and on the controller you will use. [. . . ]