User manual BEGLEC LED CROSSFIRE V1.0

[. . . ] Never expose the lens to direct sunlight, even for a short period. This may damage the light effect or even cause fire!EN - DISPOSAL OF THE DEVICE Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. [. . . ] uP button: to go up in the menu and to increase the values shown on the display. ENTER button: used to confirm your choice. MAIN MENU: To select any of the menu options, press the MENU button up to when the required one is shown on the display. Use DOWN and UP button to choose the desired menu option. once the required menu option is selected , press the ENTER button to select. To go back to the functions without any change press the MENU button during 2 seconds or just wait 10 seconds. Once the correct address shows on the display, press the ENTER button to save it. Press the MENU button for about 2 seconds to return to running mode. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the mains input of the next unit for easier linking. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Safety eye, used to attach a safety cable when the unit is rigged, see paragraph "overhead rigging" 5. This input receives instructions from a DMX-controller. DMX output: 3pin female XLR-connector used to connect the effect with the next unit in the DMX chain. Press the MENU button for about 2 seconds to return to running mode. Working Mode Used to set the unit in master or slave mode. press the MENU button until is shown on the display. Press the ENTER button, the current working mode starts blinking in the display Use the DOWN and UP buttons to select (slave in sync with the master) or slave in anti-sync with the master). once the right mode is selected , press the ENTER button to confirm. Press the MENU button for about 2 seconds to return to running mode. Blackout Mode Blackout mode: when no DMX-signal is detected, the unit goes in blackout. No blackout mode: when no DMX-signal is detected, the unit automatically switches to master mode. Once the mode is selected, press the ENTER button to save it. [. . . ] Clean with a soft cloth using normal glass cleaning products. Clean the external optics at least once every 30 days. Clean the internal optics at least every 90 days. Mains Input: Power consumption: Fuse: Sound Control: DMX connections: DMX channels used: Lamp: Size: Weight: AC 100V-240V, 50/60Hz 40 Watt 250V T6, 3A slow blow (20mm glass) Internal microphone 3pin XLR male / female 1 or 4 channels 320 LEDs (R=80 + G=80 + B=80 + W=80): 457 x 433 x 286 mm 7 kg When used in standalone or master/slave mode we strongly advice you to use the CA-8 "Wired easy controller" or RF-8SET "Wireless easy controller". [. . . ]