User manual BEGLEC LED DEVIL II VERSION 3.0

[. . . ] conformity has been established and the relevant statements and documents have been deposited by the manufacturer. This device has been designed to produce decorative effect lighting and is used in light show systems. An extremely compact, DMX-controlled, LED effect This powerful, eye-catching, LED effect uses 3 optical discs and 6 lenses to obtain an incredible, brilliant and innovative light effect!0-100% dimming and ultra fast strobe function Different user modes for maximum flexibility: DMX-control: 1 channel mode or 3 channels for full control of dimmer/strobe, colors, rotation speed/direction Standalone: automatic or sound activated with internal mic Master/slave: wonderful synchronized shows Optional CA-8 remote controller available Based on a powerful 10Watt RGBW LED: Extremely brilliant beams compared to effects with halogen lamps More dynamic effects compared to effects based on halogen lamps No lamp replacements! [. . . ] Don't use the effect in the presence of persons suffering from epilepsy. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. Check the contents: Check that the carton contains the following items: Operating instructions LED DEVIL II Mains Cable Hanging bracket + 2 bolts & 2 nuts The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Electrical installation in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable. Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these cables are compatible with balanced audio cables. pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) Pin layout XLR-5pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5 not used. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!Make sure that all units are connected to the mains. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. This input receives instructions from a DMX-controller or from another LED DEVIL II in master/slave mode. [. . . ] The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. [. . . ]