User manual BEGLEC LED MANAGER V1.2

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] OUTPUT CABLES: used to connect different 24Vdc common anode LED projectors. Load: 300W) Each cable uses a special 4pin female connector. This input receives instructions from a DMX-controller or from another LED-Manager when used in master/slave mode. DMX OUTPUT: 3pin female XLR-connector used to connect the LED-Manager with the next DMX appliance in the chain or with another LED-Manager when used in master/slave mode. INTERNAL MICRO: used for sound activated chases. ON/OFF SWITCH: used to switch the unit on/off. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. How to connect the LED-projectors to the outputs of the unit: Important: Switch the LED-manager OFF before you install the LED-projectors!The maximum total load of the LED Manager is 300W, spread over 3 colors: each of the 3 colors has a max. This means that each output cable supports 150W (max. Make sure not to overload one of the output cables!The 2 output cables (16) use a special 4pin connector. Two different types of passive LED projectors can be connected: A. LED Projectors with a special 4pin connector (ex. LED STRIP): This is the easiest way to make the connections. Fix all projectors properly and daisy chain their in/output cables until you reach the maximum allowed load. make sure to fasten the plastic ring of the connector. Example: you can connect up to fifteen "1m LED STRIP" on each output cable (total = 30m!LED GROUND LIGHT): In this case we suggest to take a 1m extension cable (with special male/female 4pin connectors) and to cut the female connector. You will find 4 colored wires inside: White wire: This is the common wire (anode) Red wire: This the power for the red LEDs (max. 50W) Greenwire: This the power for the green LEDs (max. Blue wire: This the power for the blue LEDs (max. [. . . ] Now you have the time to set the scene that you would like to reproduce when the timer is activated. When the scene is OK (don't forget to switch the blackout function off!The display stops blinking and the scene is saved. Remarks: You can abort the setting procedure and go back without saving the changes by shortly pressing the MENU button. [. . . ]