User manual BEGLEC LED OCTO PANEL V1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB SYSTEMS product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] DMX output: 3pin female XLR-connector used to connect the unit with the next one in the DMX chain. MASTER led: indicates that the unit works in master mode. SOUND led: flashes to the sound of the music detected by the internal microphone. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. DMX channel setup mode Used to set how many DMX channels the unit may occupy: 6 Channel mode: all 8 panels are programmed together 9 Channel mode: 2x 4 panels are programmed together 15 Channel mode: 4x 2 panels are programmed together 24 Channel mode: all 8 panels are programmed individually for maximum flexibility!27 Channel mode: all 8 panels are programmed individually, including 3 extra effect channels This is how to select the right DMX-channel mode: Press the MENU button until is shown on the display. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. [. . . ] Controlled by OC-1 controller: OC-1 is a special matrix controller developed to control the LED OCTOPANEL very easily: no need for time consuming DMX-programming, just plug and play!Two 8x8 matrixes (16 LED OCTOPANEL) can be controlled at once!Never use Y-splitter cables, this simply won't work! Each unit in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. [. . . ]