User manual BEGLEC LED PAR 64 V1.2

[. . . ] Stylish RGB LED-projector containing high-power 5mm LEDs: LED-PAR56: 156pcs (50 red + 53 green + 53 blue) LED-PAR64: 212pcs (70 red + 71 green + 71 blue) Beam angle = 15° Optional frost filters can be installed in the supplied filter frame to obtain a nice flood beam. many applications possible: Discotheques , DJs , exhibition booths , homes , . Very smooth RGB color changes thanks to high freq. Different working modes: Completely standalone: automatic or beat synchronized color changes (optional CA-8 controller possible) Master/slave mode: up to 16 units can be used together for wonderful preprogrammed, music synchronized lightshows. [. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. Check the contents: Check that the carton contains the following items: Operating instructions LED Projector (PAR56 or PAR64) Hanging bracket 2 Knobs to fasten the hanging bracket Filter frame Hanging bracket with knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Signal present LED: DMX-signal detected: LED blinks regularly, ready to receive instructions from a controller. DMX-signal not detected: LED blinks to the rhythm of the music, detected by the internal micro. Mains fuse: Always replace this fuse with a fuse that has the same characteristics!Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. electrical installation for 1 standalone unit: Just insert the mains cable. The unit starts working immediately in stand-alone mode Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. refer to section "C" of the operation instructions to learn how to do this. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables. The unit that has no cable connected to its DMX-input will react as "master", the others are the slave units. Make sure that all units are connected to the mains. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. You can also connect the LEDCON 01 remote controller, in this case all units will respond equally (all units have the same color) Electrical installation for two or more units in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!Make sure that all units are connected to the mains. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. [. . . ] The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. The cleaning of internal and external optics must be carried out periodically to optimize light output. [. . . ]